|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
11-09-2019, 05:00 PM | #1 |
Not Yet Wild
Join Date: Nov 2019
Posts: 23
|
Controller, Solenoid, Pot Box Mounting (old Marathon)
I have an older Marathon with the motor perpendicular to the rear end. Looking for suggestions for mounting the PB-6 pot box, Alltrax 300 amp controller, and heavy duty solenoid.
Thanks Bruce |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
02-25-2020, 10:04 PM | #2 |
Not Yet Wild
Join Date: Feb 2020
Posts: 12
|
Re: Controller, Solenoid, Pot Box Mounting (old Marathon)
I second any recommendations and especially pictures. I am looking at a long-stack motor and the clearances are going to be pretty tight near the solenoid mounting bracket. In looking at an Alltrax SR48500 controller, I am thinking that I may have to have a mounting plate fabricated for the controller and or change out the throttle linkage to buy some additional space. Hopefully there is someone who has gone through the same rebuild and can offer pictures or advice on clearing out the throttle linkage and solenoid relocation. Thanks!
|
04-13-2020, 09:09 PM | #3 |
Gone Wild
Join Date: Feb 2020
Posts: 150
|
Re: Controller, Solenoid, Pot Box Mounting (old Marathon)
Did y’all figure anything out? Here’s my redneck rigged setup.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Controller mounting | Lifted Golf Carts | |||
Help with controller,solenoid & fnr switch on a marathon | Electric EZGO | |||
Solenoid Resistor & Diode Mounting | Electric EZGO | |||
91 ezgo marathon issue 37v to solenoid, not sure on POTS or controller | Electric EZGO | |||
controller / solenoid / battery mounting questions | Electric Club Car |