|
Gas Club Car Gas DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
06-06-2010, 10:00 AM | #1 |
Not Yet Wild
Join Date: Jun 2010
Location: Rockwall, Texas
Posts: 11
|
Removing Pulley on Starter / Generator
What's the best method of removing the pulley from the starter/generator? Impact wrench I'm guessing? Also how are they threaded (any chance they're reverse). Thanks for the assist.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-06-2010, 11:33 AM | #2 |
Gone Wild
Join Date: May 2010
Location: OHIO
Posts: 1,517
|
Re: Removing Pulley on Starter / Generator
on my 87 clubcar i just use a ratchet and left to loosen and right to tighten
and the starter/Gen will go down to loosen up the belt |
06-06-2010, 09:49 PM | #3 |
Not Yet Wild
Join Date: Jun 2010
Location: Rockwall, Texas
Posts: 11
|
Re: Removing Pulley on Starter / Generator
Okay...finally got the bolt off but now I CANNOT get the pulley to come off the armature. I've soaked it with Rust Eater, used a pulley removal tool (could tell it was going to bend the pulley). I have not tried heat as I was not sure if this might cause a problem with the armature. Any advice guys?
|
06-07-2010, 07:37 AM | #4 |
Gone Crazy
Join Date: Jan 2007
Location: Chesterfield, Va
Posts: 6,021
|
Re: Removing Pulley on Starter / Generator
Just thinking out loud but you might have to disassemble the S/G, wrap the armature in a rag or two, put in a vice and try to unscrew it with a strap wrench.
|
06-07-2010, 08:25 PM | #5 |
Not Yet Wild
Join Date: Jun 2010
Location: Rockwall, Texas
Posts: 11
|
Re: Removing Pulley on Starter / Generator
Well that did it. Lube, elbow grease, lube some more yada yada...and it's off. Thanks for the advice. Man...what a pain!
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Bad generator?/Starter? | Gas EZGO | |||
is it the starter/generator | Gas Harley Davidson | |||
Removing driven pulley question | Gas EZGO | |||
Starter/ crank pulley needed (drive clutch?) | Gas Yamaha | |||
removing the drive pulley from rear end. | Gas EZGO |