|
|
|||||||
| Electric Yamaha Electric Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
  |
|
|
Thread Tools | Display Modes |
07-05-2013, 11:39 AM
|
#1 |
|
Not Yet Wild
Join Date: Jun 2013
Posts: 3
|
89 yamaha g2e
Ok I need help I have a G2E that was working fine. I ran over a puddle and it stopped working. I found the one battery wire was broke so I replaced it and noticed the wires on the solenoid where burnt. So I replaced the solenoid but now the cart will not move at all. If I bypass solenoid the cart runs but without switch being on, and the coil heats up. Is there a switch or something I am missing?. Please Help I have two daughters that love going for rides on the "Buggy"
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
07-06-2013, 12:21 AM
|
#2 |
|
Not Yet Wild
Join Date: Feb 2013
Location: So. IL
Posts: 18
|
Re: 89 yamaha g2e
Look at this post. It is the wiring diagram for the G2E carts.
http://www.buggiesgonewild.com/elect...g-diagram.html There are 3 switches (main, cut-off, and an accelerator cut-off switch). Also check the positive and negative fuses ( probably under the seat on the driver's side rear fender well). By looking at the diagram anytime the relay coil is engaged it is sending power through the resistor coil and to the tram motor. |
|
|
|
|
07-18-2013, 01:30 PM
|
#3 |
|
Not Yet Wild
Join Date: Jun 2013
Posts: 3
|
Re: 89 yamaha g2e
ok did all the checks and had a wire wrong so I had power on each side of the pedal switch fixed problem. Now I have two happy girls that get to go for rides on the Buggy again. Thanks fore all the help.
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Wanted: Yamaha G1 rolling chassis (or any Yamaha really) | Golf Carts and Parts | |||
Linear Mode
