2002 Ex-go freedom PDS smoke controler

[cgtech]

If you buy this used controller, please make sure it's set to the correct throttle type, and correct motor map for your cart before you let a wheel touch the ground. You never know what you are getting when you buy a used controller that is programmable for many different carts.

[Joatmony2k]

Originally Posted by cgtech

If you buy this used controller, please make sure it's set to the correct throttle type, and correct motor map for your cart before you let a wheel touch the ground. You never know what you are getting when you buy a used controller that is programmable for many different carts.

Thanks cgtech I could not find a used one so I’m getting a new one. I did have in mind if I found a used one I would have double check what it was set to before I install it.


Sent from my iPad using Tapatalk

[Joatmony2k]

OK after smoking the DCX controller and have check ever ting out and found nothing wrong that I could see. So i got me a Navitas 440 and install it and at first I was getting both forward and reverse signal.

I check wires from dash to the controller and found nothing I even pull the wires from the split wire loom and check them and noting. Then out of the blue all started working like it should. Today I went out and was doing some cleaning, checking lights, and ran my OTF wire from the front to the back.

I went to take it out of the shed and got both forward and reverse again. But I can turn the key switch off and then put it in forward and it would go fine but if I just flip the switch to reverse it would fault out with both limited. I can tune the key off then put it in reverse then turn key back out and it would work fine.

What is something I can check that I may have missed?