|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
08-21-2019, 08:47 AM | #1 |
Gone Wild
Join Date: Aug 2017
Location: Archdale NC
Posts: 201
|
2013 ezgo txt 48v F and R switch.
Hey gang. I have a 2013 ezgo txt 48v cart. I'm replacing the F&R switch(rocker on the dash) with an F&R switch from a newer cart (F&R rocker that mounts behind the knee). I'm looking at this diagram and was wondering if someone can sorta break it down and walk me through exactly what I need to do. I'm leaving the stock rocker switch and wiring in the dash for now so I'll basically be cutting the wire to the stock switch and running new wire from the new rocker (behind the knee) to where ever it goes. Thanks so much for the help.
Sent from my SM-N960U using Tapatalk |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-21-2019, 09:02 AM | #2 |
Gone Wild
Join Date: Dec 2009
Location: Aiken, SC
Posts: 13,173
|
Re: 2013 ezgo txt 48v F&R switch.
Center pin of your switch will tap into the wire going to pin 9, red/lt blue, pin 16 orange will go to the reverse pin and pin 8 green will go to forward.
|
08-21-2019, 09:29 AM | #3 |
Gone Wild
Join Date: Aug 2017
Location: Archdale NC
Posts: 201
|
Re: 2013 ezgo txt 48v F&R switch.
|
08-28-2019, 12:23 PM | #4 | |
Gone Wild
Join Date: Aug 2017
Location: Archdale NC
Posts: 201
|
Re: 2013 ezgo txt 48v F&R switch.
Quote:
The only thing that was different was my number 9 pin was a red wire, not red/blue. One other thing. I actually cut each wire and connected my switch wires. Should I have "tapped" into each one leaving the stock F and R switch in the loop? Sent from my SM-N960U using Tapatalk |
|
08-28-2019, 06:06 PM | #5 |
Gone Wild
Join Date: Aug 2017
Location: Archdale NC
Posts: 201
|
Re: 2013 ezgo txt 48v F and R switch.
Where's all my heavy hitters?
Sent from my SM-N960U using Tapatalk |
08-28-2019, 06:21 PM | #6 |
Gone Wild
Join Date: Sep 2017
Posts: 690
|
Re: 2013 ezgo txt 48v F and R switch.
They should be along shortly but I have to ask if you are sure the F&R switch you are installing is good?
I am assuming it is used since you stated it is out of a newer cart. |
08-28-2019, 06:50 PM | #7 | |
Gone Wild
Join Date: Aug 2017
Location: Archdale NC
Posts: 201
|
Re: 2013 ezgo txt 48v F and R switch.
Quote:
Sent from my SM-N960U using Tapatalk |
|
08-28-2019, 06:57 PM | #8 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: 2013 ezgo txt 48v F and R switch.
Do you have battery pack voltage on the center (common) terminal of the new switch when the Run/Tow is in Run?
IF not, find a way to get it there. The old switch needs to be disconnected (wire cut or whatever) , else you could tell the controller to go F and R at the same time and it might not like that much. |
08-28-2019, 07:07 PM | #9 | |
Gone Wild
Join Date: Aug 2017
Location: Archdale NC
Posts: 201
|
Re: 2013 ezgo txt 48v F and R switch.
Quote:
Kgsc stated that the wire going to pin 9 would be red/blue, but the wire from pin 9 on my cart is solid red. Sent from my SM-N960U using Tapatalk |
|
08-28-2019, 07:37 PM | #10 |
Gone Wild
Join Date: Aug 2017
Location: Archdale NC
Posts: 201
|
Re: 2013 ezgo txt 48v F and R switch.
Here's the switch I'm trying to install.
Sent from my SM-N960U using Tapatalk |
|
|
Similar Threads | ||||
Thread | Forum | |||
2013 ezgo rxv | Golf Carts and Parts | |||
2013 TXT48v bypass reed switch | Electric EZGO | |||
2013 club car Precedent vs 2013 EZGO RXV | Electric Club Car | |||
2013 ezgo | Electric EZGO | |||
2013 RXV changed factory light switch, now no turn signal lights | Electric EZGO |