![]() |
|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
![]() ![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Not Yet Wild
Join Date: Jan 2008
Posts: 2
|
![]() Problem: new solenoid - 36V to non-live side of solenoid turns motor, F/R works, speed control works while solenoid jumped - solenoid works fine in another cart - no response with normal connections. Microswitch seems to do it's job - small terminals on solenoid seem to read ok after throttle pushed. All readings seem to match another EZGO except no joy in normal mode. Any suggestions are appreciated. Thanks.
|
![]() |
![]() |
![]() |
|
![]() __________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
![]() |
#2 |
WILD
![]() Join Date: May 2007
Location: lebanon county,pa
Posts: 1,266
|
![]() Check all cables, is it wired up right?Sounds like somethings bad in the wiper or not hooked up right.These old electric are notorious for bad wiper boards and resistors.Also make sure the batteries are fully charged.
|
![]() |
![]() |
![]() |
#3 |
Not Yet Wild
Join Date: Jan 2008
Posts: 2
|
![]() Thanks - I have determine that the solenoid is not getting 36V - will trace all supply wires and switches.
|
![]() |
![]() |
![]() |
|
Thread Tools | |
Display Modes | |
|
![]() |
||||
Thread | Forum | |||
1982 G1 Body Question | Gas Yamaha |