2010 rxv

[Newbuggyboy]

Basic info
2010 rxv 48V 4 x 12v

Right now when I turn the key switch there is no click.
I tested the solenoid and it seemed bad.
The new one was the exact 36V solenoid.
I also replaced the resistor.
I also installed 5 X 2 gauge wires
3 from battery to battery
1 from pack positive to solenoid see green cable in photo
1 from packed negative to controller B-
I replace the motor brake with OEM

Key off
Volt meter shows 48V coming in to solenoid + and pack -
0v to both small post
0v to large post red cable

Key on in neutral
Volt meter shows 48V coming in to solenoid + and pack -
48v to both small post
7v to large post red cable
7v to controller B+ via red wire

I'm thinking but not sure what else to say. Some of those things were to clear up connections issues, etc..

I'm holding a sign up that say will post any info u need for help.

Just want my cart back running.

Thanks

[Jesse454545]

Right now I am having the same issue with my 2009 RXV, no click no movement, no nothing when I turn the key but I'm getting voltage to my solenoid but nothing happens. I bought this cart to fix up for myself but cant figure out what's going on with it.

[Newbuggyboy]

Originally Posted by Jesse454545

Right now I am having the same issue with my 2009 RXV, no click no movement, no nothing when I turn the key but I'm getting voltage to my solenoid but nothing happens. I bought this cart to fix up for myself but cant figure out what's going on with it.

I've been trying these, but i have no diagnostic hand held: