Ezgo ITS question

[huntingcart2393]

My current its sensor is a three wire. A power(pink wire) a ground(black) and orange wire. I’m going to change to a two wire sensor. My question is if I swap to a two wire. If I’m correct both of these will go to throttle 1&2 on the controller. Where does the sensor get power from? Or does it not need it? By the way it’s a series cart. Using an alltrax sr48500 and a reversing contractor. Thanks for any help. Attached is my current sensor. I’m only getting 8mph top speed and should be 19mph. Also I get 100% throttle as soon as I press the pedal.

2990787A-30A9-4788-9E55-CAA245741B17.jpg

[mgray70]

What kinda cart is that? I've not seen a 3 wire ITS on a EZGO before. It receives the throttle voltage from the controller and sends voltage back to the controller at different levels depending on the throttle position..

Sent from my SM-G970U using Tapatalk

[huntingcart2393]

It’s a ruff and tuff. But I completely did away with every wiring that’s ruff and tuff. I wired it exactly like an ezgo and the only think I kept was the ITS sensor. So I’m assuming if I change that to a two wire ezgo it’ll work fine