|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
03-17-2011, 03:48 PM | #1 |
Not Yet Wild
Join Date: Mar 2011
Posts: 37
|
1998 Club Car Electric noise
I just bought a 1998 Club Car Electric 48 Volt. Its got the lever below the seat to shift Forward or REverse. It makes noise when I keep the accelerator down all the way. Coasting there is no noise. It does not have regeneration braking. It sounds like a coffee grinder if any of you can recall that type of noise. I told the previous owner that it had a grinding noise. He said that all the bearings were replaced???? To me it would indicate a motor problem, but not differential or gears?? I am keeping my 1988 Yamaha gas cart until I can fix this problem. Should I be thinking to buy a 36 volt motor to speed this sloow cart up and fix both problems? Previous owner said it has high Speed gears. Its street legal. What does street legal gears include??
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-18-2011, 08:35 AM | #2 |
Gone Wild
Join Date: Mar 2009
Location: South Texas
Posts: 2,391
|
Re: 1998 Club Car Electric noise
Sounds like the Guide Ring part # 101789101 needs installed or replaced ( this acts as support for motor shaft on differential input shaft side )? This is located inside the splined shaft of motor ands acts as spacer-silencer between motor shaft and differential input shaft. Often with motor changes these are missed and or not replaced. Along with the Guide Ring you need a new retainer ring part #101822801 and adhesive to install part # 101813202. It does require the removal of motor to install.
WARNING when removing wiring use ( 2 ) wrenches, one to hold lock nut nearest motor while other is used to lossen nut holding cable in place. ( very easy for stud to rotate damaging wiring inside motor ) As cables are removed mark them with tape and location on motor housing. |
03-18-2011, 09:31 AM | #3 | |
just leave me alone
Join Date: Aug 2008
Location: Tennessee
Posts: 5,643
|
Re: 1998 Club Car Electric noise
Quote:
|
|
03-19-2011, 11:55 AM | #4 |
Not Yet Wild
Join Date: Mar 2011
Posts: 37
|
Re: 1998 Club Car Electric noise
Thanks for reply. How difficult is it to get the motor out to replace these parts? Are there any tricks to make it an easier job? How do I know if these parts will fit? Are the parts interchangeable with different year Club Cars? Not at all familiar with how to maintain an electric cart. I looked up part numbers At BuggiesGoneWild and found the part 101789101, but tried the other 2 numbers and came up empty. Where can I find these parts?
Last edited by jhp1940; 03-19-2011 at 12:26 PM.. Reason: add words |
03-19-2011, 01:26 PM | #5 |
Not Yet Wild
Join Date: Mar 2011
Posts: 37
|
Re: 1998 Club Car Electric noise
OK I ordered all the parts from Mid-America Powered Vehicles Corp. They also had a part listed as Adhesive Remover Pen - PREC part number 102573201 for $12.40 whatever that is. Where can I find instructions on how to do this? I'll try a forum search. Thanks for help
|
03-20-2011, 11:25 AM | #6 |
just leave me alone
Join Date: Aug 2008
Location: Tennessee
Posts: 5,643
|
Re: 1998 Club Car Electric noise
It may include instructions, if it's not obvious and U need help after part arrives
post again |
04-01-2011, 05:49 PM | #7 |
Not Yet Wild
Join Date: Mar 2011
Posts: 37
|
Re: 1998 Club Car Electric noise
No instructions came with the parts. Adhesive remover was a rip off. $!2 plus for a 3M over the counter adhesive remover to remove adhesive from cards or whatever. The adhesive was also a rip off as it was only a small amount of adhesive made by Loctite 4211. Not sure what the price over the counter would be but Ipaid $14.82. Not a whole lot but anyway. I looked at where the motor is mounted and at my age I decided to bring the cart to the local Club Car dealer to see what they decide is wrong. Still waiting for a call and an estimate what the charges will be to fix the problem. And what they think what the problem is? On the way over with accelerator all the way down, my wife clocked me at 21 mph. Is that normal. My gasser 1988 Yamaha does 29.4 mph. 21 feels sloow.
|
04-01-2011, 07:09 PM | #8 |
just leave me alone
Join Date: Aug 2008
Location: Tennessee
Posts: 5,643
|
Re: 1998 Club Car Electric noise
No thats not normal , 15-18 is normal without beefing something up .
|
04-01-2011, 08:37 PM | #9 |
Gone Wild
Join Date: Feb 2009
Location: Not sure yet
Posts: 500
|
Re: 1998 Club Car Electric noise
The guide rings dont wear out, but the glue does. You can remove the ring- clean it out, and use a good contact cement and problem solved. If your dealer is like any repair shop around here, they will tell you big tails about what your problem is, when in reality it is an easy fix. Becareful.
|
04-01-2011, 09:08 PM | #10 |
Not Yet Wild
Join Date: Mar 2011
Posts: 37
|
Re: 1998 Club Car Electric noise
OK I returned from the Club Car repair shop. The invoice says the problem was the Spring Centering Device. The gal up front showed me the kit. It had a bearing and snap ring plus a few shims(?). They said the charge for removing the motor and reinstalling was $102 and parts $17.07. Noise gone and it was done in one day. I thought it was a fair deal. Total cost $120.32 including tax. Now the original deal when I bought the cart included 4 tires I think 10 inch rather than the 8 inch stock tires. How much faster will this cart go with the larger tires? The original noise problem was if I floored the accelerator it would make noise but when I letup the accelerator the noise would quit.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
1998 Electric Club Car charge meter | Electric EZGO | |||
1986 electric Club Car Won't Go (clicking noise) | Electric Club Car | |||
1998 EZ GO Electric TXT | Electric EZGO | |||
04 TXT Electric rear axle noise | Electric EZGO | |||
Steering adjusment for a 1998 EZ GO Electric | Electric EZGO |