|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
04-08-2018, 05:25 PM | #1 |
Getting Wild
Join Date: Jan 2011
Location: Dayton Ohio
Posts: 130
|
93 marathon resistor arching at 2nd speed post
I installed new board and contacts,new brush. Now when I push pedal on it is dead on 1st speed . I think I seen a small spark from inside resistor case the first time I pushed the pedal. MY real question is Would 1st speed resistor being open cause a bad arching when it goes to the 2nd speed post on the board but not on the others. After looking close at old parts. That 2nd speed post is what fried on original board as well as brush.I carefully watched and ran the brush up and down the board after assembly and brush was tight against each contact .I checked with ohm meter and micro sw goes closed after brush is completely on post. Thanks; Rick
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
Tags |
1st speed dead |
|
|
Similar Threads | ||||
Thread | Forum | |||
1979 marathon sparking/arching | Electric EZGO | |||
Is this a speed controller or resistor on my 1991 Marathon | Electric EZGO | |||
Missfire and arching | Gas EZGO | |||
5TH speed resistor has a burned mark on resistor board and melted the wire | Electric EZGO | |||
Re-arching front spring? | Electric EZGO |