|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
02-25-2011, 08:17 PM
|
#11 |
|
Gone Wild
Join Date: Dec 2009
Location: Waihee, Maui, Hawaii
Posts: 262
|
Re: 91' EZGO Pot Box
Pot box sounds fine and you say you have new batteries
 Check you axle. It may be partially stripped. so it goes when you are on flat then no go on hills.just a guess. joe |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
02-25-2011, 08:19 PM
|
#12 |
|
Happy Carting
 Join Date: Dec 2007
Location: Southern California
Posts: 73,406
|
Re: 91' EZGO Pot Box
Big tires? Any Mods? Just a stock cart that can't go uphill where other carts can?
|
|
|
|
|
02-25-2011, 08:38 PM
|
#13 |
|
Not Yet Wild
Join Date: Sep 2008
Location: Olivia, N.C.
Posts: 58
|
Re: 91' EZGO Pot Box
Right... Stock all the way around..
|
|
|
|
|
02-25-2011, 09:05 PM
|
#14 |
|
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,406
|
Re: 91' EZGO Pot Box
How are you testing the batteries?
|
|
|
|
|
02-25-2011, 10:23 PM
|
#15 |
|
Not Yet Wild
Join Date: Sep 2008
Location: Olivia, N.C.
Posts: 58
|
Re: 91' EZGO Pot Box
I tested each w/ a load tester plus a VOM. All of them were 6.5v and above
|
|
|
|
|
03-01-2011, 09:26 PM
|
#16 |
|
Not Yet Wild
Join Date: Sep 2008
Location: Olivia, N.C.
Posts: 58
|
Re: 91' EZGO Pot Box
I guess it depends on the day of the week.... I took the cart out for a ride today and it did great. I got back on and tried to park it and did not want to move. ????
|
|
|
|
|
03-03-2011, 10:45 AM
|
#17 |
|
Gone Wild
Join Date: Aug 2008
Location: Cumming, GA
Posts: 313
|
Re: 91' EZGO Pot Box
The next time it does this check the motor for continuity. You may have some leads that are burnt on the inside of the motor.
Per the ScottyB MOTOR UNWANTED CONTINUITY TEST The following tests can assist in troubleshooting. Disconnect all wires to the motor and label them Make sure none of the terminals are grounded to the motor or cart (F1 terminal to motor frame) You should have continuity present between F1 and F2 and A1 and A2 but NOT BETWEEN ANY A and ANY F Terminal. If any of these test fail, the motor will not operate correctly. |
|
|
|
Linear Mode
