how can cart motor run in reverse?

[BillFurn]

CTD, Sergio, and Lance.........
Was away for couple days! will take a look, and again...... THANKS. will post back.

[DOOmsman]

A litle more, the reverse stud is just a few degrees off from the forward stud causing reverse spin,

[BillFurn]

CTD, Sergio and all that helped.....
THANKS. OK, that is awesome! That (finally :) ) was excellent reference, showing how the flow gets reversed across A1 and A2. Not finding any internal diagrams of the F/R switch really did me in. Those last diagrams explained perfectly. see.... I KNEW there were awesome guys out there!
Looking at the diagrams, you can see troubleshooting with a volt meter (at the same points) is going to be very different, depending on forward or reverse.
I also didn't realize the 2 wires (from A1 and from the coils) actually pivoted with the center movable contact.
Thanks guys, you're the bomb! I'm sure a ton of others learned along with me.
Bill

went through my manual and found this... it might help explain how resistors work

[kantuckian]

Good info for fwd/rev sw

[BillFurn]

CTD........... guess I'd be buying the beers if I ever hit FL!!
That power circuit diagram was also an excellent post. Hope I've said thanks enough times.
It's too bad that the F/R switch for this model wasn't posted before. Just a ton of good help from you guys and this board.
Man!!!! :)

[lance_214]

Originally Posted by BillFurn

CTD........... guess I'd be buying the beers if I ever hit FL!!
That power circuit diagram was also an excellent post. Hope I've said thanks enough times.
It's too bad that the F/R switch for this model wasn't posted before. Just a ton of good help from you guys and this board.
Man!!!! :)

Hey Bill....Crash has diagrams on how to draw diagrams...its nothing new..good source for info and pictures...lots and lots of pictures..and did I say pictures!