2002 DS - Pulling Motor

[fsu1tm]

Originally Posted by Gallachera89

Those 4 bolts should come out on the outside edge and you cand split them apart .. then when the case is apart you can put the brushes back and put together .. at least thats how every motor ive delt with is

This is a picture of my d&d motor but my stock club car motor came apart like this also

I think I see what you are talking about now. Unfortunately, I've got 3 of the 4 bolts out but the 4th is stuck. Almost feels like it's going to break. I've soaked in PB Blaster and will let sit overnight. Thanks for helps.

[fsu1tm]

Originally Posted by Golf cart guy

Stand the differential on its end, spray some PB Blaster, so it runs down into the splines. Let it sit. I have 100 percent success rate of getting them off.


As far as not ruining the armature, I have a foam mat that I put under where the armature will fall. Never ruined one yet. Im sure you can take a bunch of towels or something cushy and put it under.

Good call GCG. Eased a little PB Blaster on the splines, waited 30 minutes, and on the 3rd drop the rotor came off. Did it on the edge of the drive so it'd fall in the grass. A little dirt and grass clippings but nothing that didn't blow out with air gun. Thanks again.

[LukeL]

Nice [emoji1303] sometimes those armatures are on for good!

[Lochlin]

Apply some anti-seize when you reinstall to lessen the likelihood of this happening again.

[fsu1tm]

Originally Posted by Lochlin

Apply some anti-seize when you reinstall to lessen the likelihood of this happening again.

[Golf cart guy]

Originally Posted by LukeL

Nice [emoji1303] sometimes those armatures are on for good!

I haven't been beaten yet.

[LukeL]

Originally Posted by Golf cart guy

I haven't been beaten yet.

You are tougher than me then :)

But seriously, both of the two I couldn’t get had been saltwater flooded.