|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
01-27-2020, 07:52 PM | #1 |
Not Yet Wild
Join Date: Jan 2020
Posts: 7
|
2000 txt I've tried everything I know
Older txt ( shifts by my leg) will not move. I've tested motor works when power is applied manually. Tested controller. Checks out fine got desperate started throwing parts at it new controller new solenoid new ITS . I'm missing something small like I've ohm every wire I can find no breaks. Now I have 36 volts at motor and the signal starts at roughly 8 and drops to 0 volts. That's correct isn't it?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
01-27-2020, 08:19 PM | #2 |
Not Yet Wild
Join Date: Jan 2020
Posts: 7
|
Re: 2000 txt I've tried everything I know
To be clear I have 36v at a1 and s2 signal at corresponding posts starts 8 drops to 0 when pedal is depressed
|
01-27-2020, 08:26 PM | #3 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: 2000 txt I've tried everything I know
Does the solenoid click when you try to go? There should be 36v between the 2 small solenoid terminals when you try to go. This will make the solenoid click (close)
|
01-27-2020, 08:42 PM | #4 |
Not Yet Wild
Join Date: Jan 2020
Posts: 7
|
Re: 2000 txt I've tried everything I know
Yes it does. Cart originally quit at a low speed giving me only reverse now nothing
|
01-27-2020, 10:00 PM | #5 |
Gone Wild
Join Date: Sep 2016
Location: Northern California
Posts: 1,300
|
Re: 2000 txt I've tried everything I know
If it’s a series, check the mechanical f/r.
|
01-27-2020, 10:15 PM | #6 |
Not Yet Wild
Join Date: Jan 2020
Posts: 7
|
Re: 2000 txt I've tried everything I know
Will do , I have checked it once but not sure what the readings should be , micro switches checked out. When I checked the motor I applied a + and - to the motor . What sends a ground to this normally? I understand that the polarity is just reversed but I have power on both sides of the motor . Thank you for your help by the way
|
01-28-2020, 12:21 AM | #7 |
Gone Wild
Join Date: Sep 2016
Location: Northern California
Posts: 1,300
|
Re: 2000 txt I've tried everything I know
http://www.buggiesgonewild.com/elect...en-system.html
Use that link to confirm drive type. I’m not one of the experts, but when you said it lost reverse first, that made me think it might be the f/r. The contacts can get worn or the mechanism itself can get loose. The motor doesn’t care about the direction. It’s handled by the f/r. If the solenoid is clicking, it’s not in the small wires or the micro switches. All of this is assuming it is a series cart. |
01-28-2020, 01:42 PM | #8 |
Not Yet Wild
Join Date: Jan 2020
Posts: 7
|
Re: 2000 txt I've tried everything I know
So after checking the f/r switch very thoroughly I'm stumped again. Its sending signal to the motor but won't move. But when I put power to it manually it works???
|
01-29-2020, 09:13 AM | #9 |
Gone Wild
Join Date: Sep 2016
Location: Northern California
Posts: 1,300
|
Re: 2000 txt I've tried everything I know
Did you confirm it is a series cart?
|
01-29-2020, 09:17 AM | #10 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: 2000 txt I've tried everything I know
It sounds like a typical DCS controller failure. Go here to ID the drive system type by reading the description and following the flow chart > https://www.cartsunlimited.net/upgrade-suggestions.html
|
|
|
Similar Threads | ||||
Thread | Forum | |||
2000 eze go gas | Gas EZGO | |||
2000 ds | Electric Club Car | |||
2000 TXT anything to look out for? | Electric EZGO | |||
2000 | Electric EZGO | |||
2000 TXT ITS won't go | Electric EZGO |