|
09-18-2020, 02:36 AM
|
#1 |
|
Not Yet Wild
Join Date: Sep 2020
Posts: 19
|
Bad F&R switch?
I replaced the micro switches on my 99 Series cart. I am getting power to the bottom green wire but not getting anything out of the top white wire when in gear and hitting the accelerator. Any thoughts?
I ultimately think my controller is bad. The cart was intermittent before it gave out. I've already replaced the solenoid, micro switches and cleaned and inspected the potentiometer which looked clean and replaced the micro switch inside it. |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
09-18-2020, 02:51 AM
|
#2 |
|
Gone Insane
 Join Date: Oct 2016
Location: Richmond, VA
Posts: 14,215
|
Re: Bad F&R switch?
What voltage? What drive system? Actual photo of what you are dealing with.
Need all of that to begin to help. |
|
|
|
|
09-18-2020, 04:37 AM
|
#3 |
|
Not Yet Wild
Join Date: Sep 2020
Posts: 19
|
Re: Bad F&R switch?
Sorry 48v non regen. Ignore the white black wire. I had a rats nest of wiring in this cart and am rewiring it as I go. The solid white wire now runs back to the solenoid. It is also the wire I am not getting any power (using test light hooked to last negative) out of when I hit accelerator
|
|
|
|
 |
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Wiring Alltrax for reverse with single micro-switch F&R switch... | Electric Club Car | |||
| 99 club car 48 volt has rocker switch with diag plug hole in bottom of switch | Electric Club Car | |||
| 2009 Precedent run/tow toggle switch replaced with keyed switch | Electric Club Car | |||
| Just got a G9 need to know how to wire ignition switch to push pull switch ASAP! | Gas Yamaha | |||
Linear Mode
