12-18-2020, 01:19 PM | #1 |
Not Yet Wild
Join Date: Dec 2020
Location: Gainesville, Florida
Posts: 22
|
Scematic
Frustrated. I have a 1999 EZGO TXT electric cart with a series motor (all 4 posts are the same size). I've been trying to find a wiring schematic for this cart, with no luck. Seems that each 1999 EZGO schematic will include PDS (which I thought was 200 and up), or it will include a run/tow switch (which I do not have), or the forward/reverse switch does not wire like mine (differences in the C,D,A and B connections). Perhaps I'm supposed to use the above mentioned schematics, but I'm not sure how to ignore wiring of components that I do not have.
As I mentioned in another post, I have new batteries, a new FWD/REV heavy duty switch, and a new solenoid. Solenoid clicks when pedal is partially pressed, but 0V reading ant M- and B- on controller. This I'm told is leading towards an open in wiring, faulty motor, solenoid, or pedal switch. The pedal switch should be considered be good though if the solenoid clicks when it (pedal) is pressed, right? I don't see any voltage at M- and B- point of the controller when the pedal is pressed, nor do I see anything chane when the pedal is pressed to floor. I want to test motor for continuity as well as functionality (by using recommended tests on this forum). If these test show failure, then I know I would have a bad motor. But if it (motor) spins, then I have to check wiring from motor. Is there a wiring schematic dedicated to just this simple 36 volt TXT series motor golf cart available? I want to be able to understand what to do next if the motor spins from the recommended tests. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
12-18-2020, 01:24 PM | #2 |
Gone Wild
Join Date: Dec 2009
Location: Aiken, SC
Posts: 13,176
|
Re: Scematic
Like this?
|
12-18-2020, 01:39 PM | #3 |
Not Yet Wild
Join Date: Dec 2020
Location: Gainesville, Florida
Posts: 22
|
Re: Scematic
Yea, I saw that schematic, but in another search (or same search), I came across a 1999 exgo TXT "direction selector connections" drawing that showed the 4 leads off of it going to:
Wire A from A2 Wire D from S2 Wire C from M- Wire B from S1 These don't match the schematic you provided. Which is correct? Or is the direction selector connections diagram I found for something else? |
12-18-2020, 02:27 PM | #4 |
Gone Wild
Join Date: Dec 2009
Location: Aiken, SC
Posts: 13,176
|
Re: Scematic
The information I attached came from Ezgo so I would tend to believe it.
|
12-18-2020, 04:14 PM | #5 |
Not Yet Wild
Join Date: Dec 2020
Location: Gainesville, Florida
Posts: 22
|
Re: Scematic
Thanks. I think the 4 connections I posted after your schematic was for a PDS system, which I don't have. Your supplied schematic matches the wiring I have from the FWD/REV selector switch, which is what I was looking for.
|