Throttle wire routing

[Kal]

Does anyone have a picture handy of the route the throttle wire runs from the throttle to the "engine bay"? I took the dang thing apart for the teardown and I can't remember if it went between the sheet metal floor and frame. I've got pictures of dang near everything else but that.

[JohnnieB]

This might help.

Page A-1

Looks like it stays under the floorboard and goes through a hole in the frame.

[Kal]

It does help, thanks Johnnie. I thought it went only through one of the holes in that cross piece, but it looks like it goes through both of them. That means it has to run along the cross piece of the frame and go between the floor and frame and back through the two big holes by where the f/r swich sits. Does that sound about right? I was concerned that by routing it between the floor and frame it would get pinched.

[Sir Nuke]

Kal .... Although my cart is a bit newer .... the set up is the same. If you hadn't gotten it settled by this afternoon .... when I get home from work I will get under mine and take a few pictures and post them. Also where they come into the compartment.

The Master of All Things has Spoken

[Kal]

Thanks Sir Nuke, I would greatly appreciate it.

[Sir Nuke]

Originally Posted by Kal

Thanks Sir Nuke, I would greatly appreciate it.

Not a problem, glad to help

[Sir Nuke]

kal......took the pictures. I'll describe what you are seeing.....

Obviously the wires leave the pedal box and go all the way through the frame holes.....as you can see I encased my7 wires in a wire loom.

20140217_172043.jpg

the wire loom goes between the battery rack and the body and I use a ty-rap to keep them up and not get pinched by anything. You can see the "shift rod" that goes over to the F&R just above the throttle wires.

20140217_172159.jpg

if you need anything else, just ask or shoot me a PM.

[Kal]

You are the man, thank you very much for the help!