Need Instructions to Bypass OBC Please

[medney]

Thank you very much gentlemen!

[Speedchaser]

Yea but you should be able to bypass completely and junk the OBC, I think you have to loop a wire, the Dawg would know how.

[jantrree]

Maybe this will help:

http://www.evdrives.com/v/images/Bat...ss_Diagram.pdf

[plivanec]

Originally Posted by cheapjeep2

Here is what you need to do.

On your wrench, tape up one end so all that is showing is the very end, that way if you drop it you don't short out a battery and cause it to blow up.

1. Move the Tow/Run Switch to Tow.
2. On the left most rear battery, drivers side (battery number 6) disconnect the Negative lead, from the pack, this is the wire that goes through the OBC.
3. On the right most, passenger side rear battery (battery number 1) disconnect the postive lead. that goes to the solenoid.

These steps will isolate the batteries from any components so you don't short out anything.

4. Run a new wire from the Negative post of battery number 6 to the charging receptacle and hook it up where the black wire is coming out. Basically Duplicate how it is done for the Red wire going to your positive on battery number one.

5. Put the main power wire back on the positive post that you took off on battery 1 and tighten securely.

6. Put the main negative wire back on the negative post of battery 6.

Move the Tow/Run switch back to Tow.

Plug in the charger and you should be good.

The OBC will still be in the power circuit (not charging) so it will reboot before your cart can run, basically turn the key on, put it in forward, tap the throttle, you'll hear the solenoid click, and the orange light on the dash will flash for a bit and go out.

You should be good to go then.

Is this for a regen 2 cart also? I removed the regen solenoid to put in an alltrax controller (per their directions).