|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
11-21-2009, 04:06 PM
|
#1 |
|
Gone Wild
Join Date: Mar 2009
Location: Brooksville, FL
Posts: 150
|
Charger not working
Early 90's EZGo charger quite working. Manufacture date on charger, 9-xx-90. Charger has been working well until middle of last week. Found 120volt wire from fuse block to relay on circuit board corroded off. Replaced, but still no go. All other wires look good. There is 120 volts to relay but not going thru relay to timer terminal. Have 29 volts from cart to terminals inside charger. About 8 years ago I replaced circuit board. Back then I think I was told to jumper directly from the 120 volt fuse to the terminal on the timer mechanism bypassing board. Charger worked so replaced board. Would that be correct procedure? Print on charger face ==Industrial Battery Charger # 20484. Any help would be appreciated. Ard Ardb@aol.com
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
11-21-2009, 09:08 PM
|
#2 |
|
Gone Wild
Join Date: Jan 2009
Location: Texas Panhandle
Posts: 170
|
Re: Charger not working
I think that 29 volts is to low for the charger to kick on you may try charging your batteries two at a time with your 12 volt automotive charger to get pack voltage back up and see if it kicks on
|
|
|
|
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| powerwise charger not working | Electric EZGO | |||
| Club Car Charger Not Working | Electric Club Car | |||
| 36v club car charger not working | Electric Club Car | |||
| my charger quit working | Electric EZGO | |||
| How Do I Know If My Charger Is Working??? | Electric Yamaha | |||
Linear Mode
