g1 carb removal and cleaning

[derowe57]

New to the game of cart repair. Ive got aa g1 and will not start. Pump was not working so I replaced with a new one. Gas getting to carb. Bowl is full.i suspect carb is gummed up. So I Brett remove carb to clean it but I don't see e how the oil line separates from carb. Any. Help would be appreciated. Also what is the best way to clean this carb?

[1moretoy]

for cleaning, get a can of spray carb cleaner. take everything apart and make note of how it goes back together. spray everything down including all the little tiny holes (safety glasses required cause you don't know where the spray may come back out) I also burn the paper off a bread tie and use the tiny wire that is left to run into the little holes. make sure the needle moves freely when the float moves. (I spray a little WD-40 on the needle before installing it)

[derowe57]

Thanks for the info, I will use it as soon as I figure out how to remove the oil line. It looks like there are metal bands around the the oil line at the carburator. I don't want to pull to hard and break the line. Any suggestions on this problem. Does the oil line just pull off of the carb? How is it attached?