|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
03-01-2021, 08:12 PM | #1 |
Gone Wild
Join Date: Aug 2014
Location: Akron, Ohio
Posts: 189
|
Need help ezgo txt dcs
Have an ezgo dcs that had an upgraded motor, axe controller, and the original fnr mechanism. Cart would click but not move. Upgraded the fnr mechanism to scotty's kit however cart would still click and not move. I bought a new fsip controller and cart still clicks won't move.
For the its the white wire never drops below 10v with the pedal all the way down. Wiring is intact and ohms okay through the entire cart. Pedal clicks solenoid just won't move. Motor tests okay. Batt pack is okay. IDK where else to look now and don't want to throw any more money at this cart. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-01-2021, 08:15 PM | #2 |
Gone Wild
Join Date: Aug 2014
Location: Akron, Ohio
Posts: 189
|
Re: Need help ezgo txt dcs
Picture of the controller with the its hooked up
|
03-02-2021, 01:35 PM | #3 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Need help ezgo txt dcs
A DCS is a Sepex drive, so the cart isn't a DCS or someone has converted it to a series drive.
Are you sure the controller is compatible with an ITS throttle? (Controllers used with pot-box throttle look the same.) |
03-03-2021, 09:16 PM | #4 |
Gone Wild
Join Date: Aug 2014
Location: Akron, Ohio
Posts: 189
|
Re: Need help ezgo txt dcs
Sorry it's a series cart. Called fsip and they forgot to send me a its convertor. I installed that and the cart is still doing nothing. Wire wire voltage now goes from 0.5 to 1.8 full throttle
|