|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
07-19-2010, 02:30 PM | #1 |
Not Yet Wild
Join Date: Jul 2010
Location: Campbell, Ca.
Posts: 15
|
2002 EZ GO 295 Pulsar Spec
I have a question pertaining to the Pulsar Coil ohmage I should have when measuring across the terminals. I have 20 but my manual is calling for 680+, which would be correct?
If I rotate the engine by hand I can see the signal fall off when it reaches the gap but what a difference in spec and true reading. I bought this cart non running and have ordered a carb and fuel filter for it, should be done I hope... |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-19-2010, 10:16 PM | #2 |
Not Yet Wild
Join Date: Jul 2010
Location: Campbell, Ca.
Posts: 15
|
Re: 2002 EZ GO 295 Pulsar Spec
Did some more reading at another site and found the spec to be 20 with about .5 A/C volts while cranking.
I don't know the correct air gap but mine is at about .029 after cleaning the hardened mud and I now have a strong spark, can't wait for fuel components. |
|
|
Similar Threads | ||||
Thread | Forum | |||
Compression spec help on HD 69D | Harley Davidson | |||
Questions about G16 Rebuild Torque Spec? | Gas Yamaha | |||
G-14- piston ring end gap spec | Gas Yamaha | |||
spec help needed | Gas Yamaha | |||
g16 valve lash spec | Gas Yamaha |