|
Electric Yamaha Electric Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
03-19-2020, 01:17 AM | #1 |
Not Yet Wild
Join Date: Mar 2020
Posts: 2
|
DC-AC conversion solenoid issue.
I have recently installed the Navitas 600 Amp DC/AC conversion in my 2017 Yamaha Drive 2. Installation went well until I went to turn on the cart and was met with an error given in the Navitas app. It’s says “main solenoid current is too high”. “Check resistance if main solenoid coil”. I received this error with the stock solenoid installed as well as with the new 350 amp solenoid that I also purchase. Has anyone experienced this error and what did you do to correct it. Any ideas would be appreciated even if you haven’t experienced the issue.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-19-2020, 01:18 AM | #2 |
Not Yet Wild
Join Date: Mar 2020
Posts: 2
|
Re: DC-AC conversion solenoid issue.
“Check resistance OF main solenoid coil” not IF main coil. Sorry
|
03-21-2020, 02:16 PM | #3 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: DC-AC conversion solenoid issue.
So, try again with no solenoid coil connected. If error remains, bad controller.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Conversion issue | All things Lithium | |||
48v Conversion Alltrax issue | Electric EZGO | |||
6-8v conversion now here's my issue | Electric Club Car | |||
Solid state conversion issue | Electric EZGO | |||
Charging issue after conversion | Electric Club Car |