|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
06-26-2022, 09:22 PM | #11 |
Gone Wild
Join Date: Sep 2021
Location: Pa
Posts: 279
|
Re: RXV Curtis Controller won't move
The controller will check the reverse buzzer during the startup tests. It's one of the last tests in the sequence and will not pass if it doesn't see it. I believe on the Curtis units the reverse buzzer can be turned off in the settings. You'll need to get the connection clean enough so the handheld can communicate with the controller. I would take a close look at the wiring harness for corrosion or poor connections. Check the run plug under the cup holder, it's a common failure point.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
36 volt ez go/ curtis controller wont move | Electric EZGO | |||
1999 TXT DCS w/Curtis controller will not move after being towed in run mode | Electric EZGO | |||
Can i change out curtis controller 1264-5407 to a curtis 1510A-5251 by repin the con | Electric EZGO | |||
Stock curtis 300amp controller to Alltrax SR controller for a 94 club car ds | Electric Club Car | |||
Is the Curtis 1311-1101 Controller Handset PMC a good controller | Electric EZGO |