|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
08-14-2015, 01:12 PM | #1 |
Not Yet Wild
Join Date: Aug 2015
Posts: 14
|
Oil injector information needed for G1
Hi,
I am new this forum, and have a newly acquired 1985 G1 Yamahauler cart. My question is regarding the oil injector housing. Is this a dry sump with the gear that drives the injector or is this to be oil filled? I see some black tar residue in there during the rebuild and don't want to ruin it if I run it dry. There looks to have been a seal on the outer oil gear cover plate where the clutch goes on the shaft. Any info regarding this part of my rebuild would be very helpful. Thanks! |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-14-2015, 01:58 PM | #2 |
maintaining a low profile
Join Date: Oct 2009
Location: SW Virginia USA
Posts: 6,314
|
Re: Oil injector information needed for G1
|
08-14-2015, 10:03 PM | #3 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Oil injector information needed for G1
The process of purging all the air from the oil system is a pain. Read up. Mix your own gas until it has had time to pump its oil for a while. One small air bubble in the pump or line is more than plenty of time to kill the motor. Just keep in mind that one fill of the oil tank is supposed to last about 10 tanks of gas. The flow through the oil tank is quite slow, and air trapped in the oil pump may never come out without proper purging. Download the manual....its here.
|
08-15-2015, 01:56 AM | #4 |
Not Yet Wild
Join Date: Aug 2015
Posts: 14
|
Re: Oil injector information needed for G1
Thank you for the information. I have a manual on the way. I am a bit concerned about the gear that drives the oil pump. It looks like the cover has a gasket and the gear inside should be run in a gear oil of some sort. However the seal that is on the cover where the clutch goes through and engages the gear is toast. Has anyone ever changed this seal and if so, where can I find it?
|
08-15-2015, 09:58 AM | #5 |
Sometime's............
Join Date: Oct 2007
Location: Tacoma Washington
Posts: 11,874
|
Re: Oil injector information needed for G1
No oil, just grease. Seal part# 93112-53004-00.
|
08-16-2015, 10:15 PM | #6 |
Not Yet Wild
Join Date: Aug 2015
Posts: 14
|
Re: Oil injector information needed for G1
Thanks for the help! I will premix for now and repair when its running strong.
|
08-23-2015, 10:37 AM | #7 |
Not Yet Wild
Join Date: Aug 2015
Posts: 14
|
Re: Oil injector information needed for G1
Does anyone know how much grease to put in the oil injector gear box?
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Information needed | Gas Yamaha | |||
textron charger information needed | Electric EZGO | |||
Additional lift information needed | Lifted Golf Carts | |||
1992 ez go information needed | Gas EZGO | |||
Engine swap information needed | Gas EZGO |