|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
03-15-2016, 06:32 PM | #71 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,410
|
Re: Alltrax XCT custom controller & throttle settings
Also you will show lower speeds if your cart just can't make top rpm due to lack of power or amp delivery or motor maxing out.
All the Dana rears are 12.44:1 |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-15-2016, 07:02 PM | #72 |
Old Sky Soldier
Join Date: Dec 2011
Location: Kentucky
Posts: 3,881
|
Re: Alltrax XCT custom controller & throttle settings
If you measure the tire height, you will find it different than what the side wall says. Mine says 20.5 on the side wall, but I measure 19". That works out closer to the GPS speed. Does anyone else have the same difference.?
|
03-15-2016, 07:58 PM | #73 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,410
|
Re: Alltrax XCT custom controller & throttle settings
I didn't measure mine but I bet they grow if I puff them up - I like the soft knobbies around the ranch and I know it cuts into my top speed but, who cares?
|
03-15-2016, 09:16 PM | #74 |
Gone Wild
Join Date: May 2012
Location: Rio Verde, Az
Posts: 7,173
|
Re: Alltrax XCT custom controller & throttle settings
To calibrate my speedometer, I put masking tape on my garage floor and on the tire and rolled it exactly one revolution using a square to make sure the tire was at the same position. I then measured how far it moved. With my 18 inch tires it was 53.25 inches. That is close enough for my speedometer. I calculated my motor RPM for 25MPH and set that as my max in the Alltrax. My GPS and my speedometer both max at 25MPH as they should. Doesn't take long to get there either. On level ground, it's running about 70 Amps at that speed. (about 4500 RPM with my 9:1 Gears)
(18 * pi) = 56.55 so my tire diameter is effectively under 18 inches. (more like 17) Tires had 22 psi in them which is what I run. |
06-27-2016, 04:52 PM | #75 |
Gone Wild
Join Date: Aug 2009
Posts: 14,245
|
Re: Alltrax XCT custom controller & throttle settings
I had some time today to dial in the settings on my XCT400. The screenshots are here: http://www.buggiesgonewild.com/membe...ml#post1289541
My cart has a 6" lift with 22" tires. Stock 3.3 HP AMD motor. |
Tags |
xct400 xct500 xct500 |
|
|
Similar Threads | ||||
Thread | Forum | |||
Alltrax controller settings | Electric EZGO | |||
Alltrax settings | Extreme DC! | |||
Alltrax dcx settings | Electric EZGO | |||
Alltrax 500A controller...cant get 100% throttle | Electric Club Car | |||
Settings on alltrax controller? | Electric EZGO |