12-19-2016, 11:18 PM | #1 |
Not Yet Wild
Join Date: Dec 2016
Posts: 1
|
Voltmeter issue
This is my first post and I hope I did this correctly. I recently bought a LED voltmeter for my 98 48volt club car. Installed it using the positive and negative from the first and last battery. Then another wire from the switch. Works great until I go to charge and then it stays where it shows it was last used at. Will work again once I take the terminal off the battery for a few minutes to "reset" I am guessing. Any help would be great. Thanks. God Bless
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
12-20-2016, 08:37 AM | #2 |
Gone Wild
Join Date: Feb 2011
Location: Chattanooga TN
Posts: 2,105
|
Re: Voltmeter issue
Wire the positive from the meter to the key switch with the other wire. That way it will be reset every time you turn the key off. Electrically they are the same point.
|
12-20-2016, 09:46 AM | #3 | |
Gone Wild
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: Voltmeter issue
Quote:
What model meter do you have? The SOC bargraph meters normally reset to full when they sense charging voltage levels for several minutes. |
|
12-20-2016, 10:08 AM | #4 | |
Gone Wild
Join Date: Feb 2011
Location: Chattanooga TN
Posts: 2,105
|
Re: Voltmeter issue
Quote:
|
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Voltmeter on an RXV? | Electric EZGO | |||
G22 Voltmeter | Electric Yamaha | |||
DC Voltmeter help | Electric Club Car | |||
LED Voltmeter | Electric EZGO | |||
Using voltmeter | Golf Carts and Parts |