|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
07-27-2013, 06:51 PM | #1 |
Not Yet Wild
Join Date: Jul 2013
Location: Sale Victoria. Australia
Posts: 22
|
83 Marathon engine clutch puller bolt dimensions
Hi all I have been searching thru old posts trying to find some info on the clutch tool Can somebody direct me to the posts that have this Info Many thanks Old Browny
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-28-2013, 01:34 AM | #2 |
Not Yet Wild
Join Date: Jul 2012
Location: Missouri
Posts: 55
|
Re: 83 Marathon engine clutch puller bolt dimensions
In the ezgo gas section at the top of the page there is a "sticky" referencing clutch bolt size.... If u look there .... There is a pic of a homemade clutch pulled... I think the outside bolt is 3/4 fine thread about 2 1/2 inches long and a piece of hard steel rod approx 3 inches long
|
07-29-2013, 11:08 AM | #3 |
Not Yet Wild
Join Date: Jul 2013
Location: Fishers, IN
Posts: 48
|
Re: 83 Marathon engine clutch puller bolt dimensions
I just took mine off for the first time. used a 3/8 steel rod that I had to buy in a 3 foot section at the hardware store....cut it down to about 3 inches, then my bolt that fit in clutch was metric. Sorry...can't find the size that I used....but it's very close to a 9/16" fine thread bolt. Mine was very hard to get off. Used a impact and still took a good 10 min. to get it off...even bent the 3/8 steel rod.
Good luck |
|
|
Similar Threads | ||||
Thread | Forum | |||
Yamaha Clutch Puller Bolt From Snowmobile??? | Gas Yamaha | |||
G1 Clutch Puller Bolt Sources | Gas Yamaha | |||
Bolt size for driven clutch puller | Gas Yamaha | |||
Clutch puller bolt | Gas Club Car | |||
Can someone tell me specs for clutch puller bolt? | Gas Club Car |