48 volt TXT solenoid won't engage.

[buckeyejudge]

Originally Posted by kgsc

If you look at the schematic they should have pack voltage when activated

If only I had this schematic. Where can I find that? I have a diagram you attached and another Johnnie sent, but I don't see activated values on either. I'm sorry if I don't know how to read these...

[JohnnieB]

Originally Posted by buckeyejudge

What am I looking for, approx 48 volts when each is satisfied? Do I remove the harness to check or do it while attached?

Sent from my SM-G950U1 using Tapatalk

It is more like 51V if the batteries are charged.

Measure the voltage with the plug plugged in.

Originally Posted by buckeyejudge

If only I had this schematic. Where can I find that? I have a diagram you attached and another Johnnie sent, but I don't see activated values on either. I'm sorry if I don't know how to read these...

Everything in the drive system, except the throttle, runs on battery pack voltage.
Lights, radios and other accessories typically run on 12V.

Here's a service manual for it, maybe it'll help.

[buckeyejudge]

I'm unable to open the PDF, it says its corrupted, but I think its something with my account. Can you email it to me?

I appear to have full pack voltage at all of those pins, but I now have a checklist of what and how to check, so I'll be going through it again.