overhead radio console

[jay_in_cgohio]

Thinking I want to add a overhead radio console to the cart. How are all of you hiding the power wires? I see how I could route it through the windshield frame but once it hits the bottom of the frame I don't see a good way to hide it.

[jay_in_cgohio]

Nobody has one of these?

[nobuckbuild]

it would be easier to run the power down the rear roof supports through the seat backs or drill a cheater hole on the underside for the bracket that bolts to the cowl and drill the cowl for the wires to go up through the windshield frame

[jay_in_cgohio]

I think the rear supports would be the best. Looking at the front I just dont see a way to hide them completely.

[XcessiveCarts]

I do alot of these installs. On a DS, I run the wires down the front frame, exit out the bottom right after the bend. And then I drill a hole in the mounting tab and thru the body, then run the wires to battery. Use Black wire and since you only see less than 1" of Black wire between Black Frame, its not very noticeable. My customers all seem to be happy with this. On a Precedent, I run the wires down the front frame, then under the cap that hides the mounting bolts I make a 90 degree turn and run wires thru body.