breather question on my cc

[on_the_fly]

i added a lift today to my cart. i made the lift myself and i droped the front of the motor to help keep it at the factory angle for oil flow but noticed now my air intake tube is about half flat against the black box beside the air box. has anyone else had to deal with this, do i need to relocate that box, or is there a hose made to adapt around this issue, i havent had that box apart to look and see if i could notch it out some way. just looking for some thoughts. o and the lift is 7 and a half inches and i dropped the front of the motor 3. this with fatcory tires put my floor board at 19 inches off the ground. and im looking to run 23x11x10's just havent bought them yet.

[lockman1]

Yep!
That happens when you lower the front of the engine cradle!

Here's a link for an intake tube that'll resolve that issue:
http://www.buggiesgonewild.com/gas-c...ubcar-gas.html

and some before and after pics of mine!

[on_the_fly]

thanks lockman. n yep my intake tube looks just like the pick.

on mine i remade the whole pice out of the rubber instead of adding a pice of plate looks factory and just reused the two bolts that were there. new pice is out of 1/4" (worked great)

[imjman57]

THANK YOU LOCKMAN1 AND BIONIC CARTS AND CUSTOMS !!!!!! lowered my craddle last week. hope I can find the part

[lockman1]

On~
post a pic of yours... I found that if ALL of the bends are rubber,
at fast accelleration, the bends will collapse, causing the engine to choke.
Been there... Done that... see my "jury rig" pic below.

im~

Any Briggs and Stratton small engine repair shop can order them for you!
(I had to order mine!)

[on_the_fly]

well here it is. home made 7 inch lift. as of now i got $30.oo bucks into it. all thats left is fix this intake issue (although i drove the cart today and it seem to do fine but it has to only be getting half air so im fixing). need to ajust the brakes and need tires n wheels now.