|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
04-10-2020, 02:36 PM | #1 |
Not Yet Wild
Join Date: Apr 2020
Posts: 3
|
Cart is free floating, Jumps back a few inches then starts beeping, Won't Run
First Issue so I just need guidance on where to start and then I can go off to the deep diving on resolving the issue.
Wife goes to mail box, comes back and parks it in garage. She parked it all crooked and my OCD just wanted to straighten it out. I turn key and it jumps back a few inches and then start loud beeping nonstop. Won't start. It beeps no matter where the key is turned, Reverse, N, Drive. I turn key to off and I also notice its free floating, like i can roll the cart forward or backwards and if i was on any type of incline it would just roll away. Its a 2012 48V RXV I believe... maybe |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
04-10-2020, 02:50 PM | #2 |
Gone Wild
Join Date: Mar 2014
Location: NE Indiana & SW Florida
Posts: 3,238
|
Re: Cart is free floating, Jumps back a few inches then starts beeping, Won't Run
Sounds like you will be needing a new motor brake. Buy only a EZGO OEM brake.
|
04-10-2020, 03:12 PM | #3 |
Not Yet Wild
Join Date: Apr 2020
Posts: 3
|
Re: Cart is free floating, Jumps back a few inches then starts beeping, Won't Run
|
04-10-2020, 03:25 PM | #4 |
Gone Wild
Join Date: Mar 2014
Location: NE Indiana & SW Florida
Posts: 3,238
|
Re: Cart is free floating, Jumps back a few inches then starts beeping, Won't Run
Yes that is the right EZGO number.
Replacing the Park Brake on an E-Z-GO RXV Remove the two T27 torx screws on the rear cover Choke the wheels Disconnect the negative cable on the battery pack Turn the ignition key to reverse, wait till the reverse indicator becomes silent then turn key off Disconnect wire harness from motor brake Remove the three 10mm hex screws and lock washers from brake If bolts are rusty replace them Remove brake if there is residue on motor be sure to clean it use a wire brush Position the brake with the connector at the top, install the three hex screws loosely. Connect wire harness to the motor brake, re-connect battery negative cable Turn ignition to neutral, turn Run/Tow switch to Tow position, this provides power to the brake to align the disc material Set torque wrench between 53 to 65 in. lbs (6-8 Nm) and tighten screws be sure not to over tighten Turn key back to the off position Move Run/Tow switch back to Run position Put rear back cover on |
04-10-2020, 05:55 PM | #5 | |
Not Yet Wild
Join Date: Apr 2020
Posts: 3
|
Re: Cart is free floating, Jumps back a few inches then starts beeping, Won't Run
Quote:
|
|
|
|
Similar Threads | ||||
Thread | Forum | |||
floating flange fo 1979 Harley golf cart | Harley Davidson | |||
turn key, 09 RXV jumps a little and then beeping alarm sounds | Electric EZGO | |||
08 club car precedent jumps hard when it starts moving | Electric Club Car | |||
Lift install off 3 inches front vs. back | Electric Club Car | |||
96 club car quits and starts back later | Gas Club Car |