|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
04-26-2020, 04:29 PM | #1 |
Not Yet Wild
Join Date: Oct 2011
Posts: 4
|
98 ezgo no go
By passed reed switch
replaced solenoid (no click when ITS activated) 36.4 voltage ITS tests OK Pin 10 36 volts Pin 9 36 volts Pin 7 little or no voltage (I feel this has something to do with my problem) Any ideas anyone |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
04-26-2020, 05:35 PM | #2 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: 98 ezgo no go
What is the voltage on the solenoid's small terminal with the red, yellow and yellow/white wires on it?
|
04-26-2020, 05:41 PM | #3 |
Not Yet Wild
Join Date: Oct 2011
Posts: 4
|
Re: 98 ezgo no go
Thanks Johnny but forgot to mention my soleniod doesn't click
|
04-26-2020, 06:01 PM | #4 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: 98 ezgo no go
With controls set for driving and no voltage on Pin-7 of a DCS controller (Curtis 1206SX) indicates the solenoid's coil is bad or no voltage is getting to the other side of the coil.
Since you've tried two solenoids, chances are there's no voltage getting to the solenoid coil. You've got the reed switch bypassed, so the likely suspects are the Run/Tow switch, F/R switch and the keyswitch. Or could be a loose wire to one of those switches. |