04-20-2020, 08:50 PM | #31 |
Gone Wild
Join Date: Dec 2019
Posts: 193
|
Re: 10 bolt clone blocks.
Do I need to run a breather along with the pulse line? Or will the pulse vent enough?
Sent from my iPhone using Tapatalk |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
04-21-2020, 01:21 PM | #32 | |
Crazy Ole Man
Join Date: Jan 2016
Location: Owego NY
Posts: 2,758
|
Re: 10 bolt clone blocks.
Quote:
https://affordablegokarts.com/pages/...38625c16&_ss=r |
|
04-21-2020, 06:08 PM | #33 | |
Gone Wild
Join Date: Dec 2019
Posts: 193
|
Re: 10 bolt clone blocks.
Quote:
Thank you sir. One question. Just got the VC adapter for air filter in today and it has a brass fitting on it. Could I use that? Sent from my iPhone using Tapatalk |
|
04-21-2020, 06:15 PM | #34 |
VC 460 CLONE GONE WILD
Join Date: Oct 2014
Location: Ray BY The Bay NJ
Posts: 10,639
|
Re: 10 bolt clone blocks.
That is for venting the crankcase . Since it is upstream from the throttle plate I don't think there would be enough pulse to run a fuel pump. Nice piece of machining there.
|
04-21-2020, 06:35 PM | #35 | |
Gone Wild
Join Date: Dec 2019
Posts: 193
|
Re: 10 bolt clone blocks.
Quote:
Thank you sir. I’ll add the vent there and see if the valve cover port works for the pulse. Sent from my iPhone using Tapatalk |
|
04-24-2020, 06:25 PM | #36 |
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,443
|
Re: 10 bolt clone blocks.
I put my pulse under the rocker cover, meaning low on the side so it comes out under the partition in there. The airbox return is above the partition. I also threaded that hole and ran it to my remote airbox. The pulse I used a smaller fitting takes about a 3/8 hole its maybe 1/8npt. I did another clone before and carb pulse blew too much pressure at idle had to run a return line using the stock G9 pump. So this one is fine until I do a speed run then it will puke tiny bit of oil in the line and start starving for fuel later. The line runs way forward to front of fuel tank almost to floor of cart. Normally it is fine I don't hit over 5K rpm unless I do a speed run. I bought a valve and hose to change up the pulse line hoping I can fix it but not got to it need to get the new carb cable connected first. Some people have run pulse above partition in top of cover and had it work but that is vented part to your airbox, there is that valve in there.
I tried the governor hole, the crank slings oil at that hole like nobodies business. |
|
|
Similar Threads | ||||
Thread | Forum | |||
bolt length and bolt sizes | Gas Yamaha | |||
Clone header bolt | Big Block Talk! | |||
Starter Bolt Broke Use other bolt question | Electric EZGO | |||
Clone Big Blocks | Big Block Talk! | |||
96 DS stock drive clutch bolt size (exterior bolt) | Gas Club Car |