|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
08-09-2011, 07:57 PM | #1 |
Not Yet Wild
Join Date: Jun 2011
Location: Shelby, NC
Posts: 25
|
ezgo light wiring question
I purchased one of the recessed light kits a while back and installed no problem. I recently purchased a new dash and radio and decided to add a new rocker switch with led light. The old switch had 2 wires red and green. The new rocker switch takes three wires power ground and whatever your hooking to(lights). I wired everything up like i thought would work with the green being ground.....wrong. anyway to make a long story short the only way i could make work was wire the green to the switch and leave the red disconnected. Everything works as it should, just want to make sure this is correct. Thanks
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-09-2011, 08:24 PM | #2 |
Stay thirsty my friends!
Join Date: Jan 2007
Location: Suburban Chicago
Posts: 24,286
|
Re: ezgo light wiring question
It is incorrect. The switch wants a +12v coming in and a +12v (load) going to the lights. The lights get grounded to a -12v terminal. The third wire on the switch also grounds to a -12v terminal. This allows the switch to make/break the positive wire, and allows the LED in the switch to operate correctly.
Get it? |
08-09-2011, 08:29 PM | #3 |
Gone Wild
Join Date: Jul 2011
Location: Houston, TX
Posts: 2,901
|
Re: ezgo light wiring question
He is correct! The third prong is for the led light on the rocker itself but does have to wired up the way gman said!
|
08-09-2011, 08:45 PM | #4 |
Not Yet Wild
Join Date: Jun 2011
Location: Shelby, NC
Posts: 25
|
Re: ezgo light wiring question
I hope i gotcha lol. I've got a seperate 12v battery wires ran to+ and- on battery. the the green wire from the original switch is wired to new switch is the only way i can get it to work properly. This will not work? If not what should i hook red wire too? Im a descent mechanic and fabricator but an idiot at electrical lol.
|
08-09-2011, 10:37 PM | #5 |
Stay thirsty my friends!
Join Date: Jan 2007
Location: Suburban Chicago
Posts: 24,286
|
Re: ezgo light wiring question
Run a wire from +12v of the battery to 12v terminal on the switch.
Run a wire from LOAD terminal of the switch to both of the positive wires of the lights. Run a wire from -12 of the battery to both the GROUND terminal on the switch AND both of the negative wires of the lights. Done. |
|
|
Similar Threads | ||||
Thread | Forum | |||
Light Kit Wiring | Electric Club Car | |||
EZGO Electric Wiring Question | Electric EZGO | |||
2004 e-z go wiring light & rear light | Electric EZGO | |||
1995 EZGO medalist wiring question | Electric EZGO | |||
93 ez-go directional light wiring | Gas EZGO |