|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
09-12-2011, 08:49 PM | #11 |
Warthog cart
Join Date: Aug 2011
Posts: 502
|
Re: EZ-GO No spark, looking for pulser?
I went looking in the shop because I knew I had a chunk of copper and a chunk of aluminum from various projects.I found the aluminum and mounted it up on the frame behind the air cleaner.The wires for the pulser reached just fine, the other two I had to extend.It's a pretty tidy looking job anyhow, and works fine.Plus it's quite accessible unlike the location of the old ignitor box.
Once I had it mounted, just for kicks I put the plug in and tried to start it.I got a few pops and farts but nothing else.It's been sitting for years so I think a good going over of the carb will help.But still, now I know it will run. I'm going to check voltage at the output side of the starter solenoid.Hopefully that's the reason it doesn't crank.Once I get it cranking off the pedal, and running I can work on that FNR switch. Thanks kindly though, this problem is solved.I'll now begin pestering you guys in new posts that relate to the other problems I'm having. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-12-2011, 11:13 PM | #12 |
Not Yet Wild
Join Date: Sep 2011
Posts: 27
|
Re: EZ-GO No spark, looking for pulser?
I have a txt shutle 2+2.
no spark at all. i tested the ignition coil and there is an open circuit betwen the 2 spark plug wire. I believe the ignition coil is dead. am i right? as it is a 4 cycles engines (with 2 cylinders) can I replace it with an HEI? Impossible to find one on the net. thanks for your help I am desesperated and can not afford to spend 200$ on a brand new genuine ignition coil. cheers |
09-12-2011, 11:32 PM | #13 | |
Warthog cart
Join Date: Aug 2011
Posts: 502
|
Re: EZ-GO No spark, looking for pulser?
Quote:
As far as testing the coil, did you use a voltmeter and test it according to factory procedure? |
|
09-18-2011, 06:52 PM | #14 |
Not Yet Wild
Join Date: Sep 2011
Posts: 27
|
Re: EZ-GO No spark, looking for pulser?
yes I test it according to the user manual. I have 3.6 Ohm between +/- wire and I have 16kOhm between spark plug wires
|
09-18-2011, 08:04 PM | #15 |
Gone Wild
Join Date: Apr 2011
Location: Washington State
Posts: 385
|
Re: EZ-GO No spark, looking for pulser?
emma...,
those readings sound normal for the coil. you probaly have a bad ignitor, replace it with the 4 pin hei. |
09-22-2011, 11:13 PM | #16 |
Not Yet Wild
Join Date: Sep 2011
Posts: 27
|
Re: EZ-GO No spark, looking for pulser?
thanks for the tip, but what is and where is the ignitor?
sorry i feel dumb |
09-22-2011, 11:40 PM | #17 |
Gone Wild
Join Date: Apr 2011
Location: Washington State
Posts: 385
|
Re: EZ-GO No spark, looking for pulser?
believe its located next to solonoid, a small electronic box with 5 wires .
|
09-25-2011, 10:40 AM | #18 |
Not Yet Wild
Join Date: Sep 2011
Posts: 27
|
Re: EZ-GO No spark, looking for pulser?
Ok I found it, is there a way to test it before to replace it? just to be sure this is the problem?
if not do you have some link to find HEI? I tried on google but not easy to find. |
09-25-2011, 08:47 PM | #19 |
Gone Wild
Join Date: Apr 2011
Location: Washington State
Posts: 385
|
Re: EZ-GO No spark, looking for pulser?
The next test i would do is this. Remove a spark plug,ground the case,and position so you can see the electrode.
Remove the +wire from the ignition coil. Jumpr a wire from The positive on battery to the + terminal of the coil. crank the motor, you should see a spark from your spark plug, if pulsar and ignitor are working properly. If you get a spark, then the problem lies between the ignition switch and the coil, probaly one of your micro switches. Let me know , if no spark,then we chceck pulsar, here is a link to ebay ,where several hei are offered. http://www.ebay.com/sch/i.html?_from...All-Categories |
09-26-2011, 07:57 AM | #20 | |
Warthog cart
Join Date: Aug 2011
Posts: 502
|
Re: EZ-GO No spark, looking for pulser?
Quote:
I got my HEI from my fathers junk distributor which works just fine, but you can also get them easily from a salvage yard very cheap.Grab a few of them and have Autozone test them.You don't even need the distributor.If you look for trucks that have been wrecked, you can bet they still ran.HEI should be about $5 at a junkyard compared to $18-$25 + shipping on Ebay. Ebay is great if you can get a warrantee on the item, I just love a trip to the junkyard. |
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Pulser coil ohm question | Gas EZGO | |||
pulser ohms | Gas EZGO | |||
pulser coil | Golf Carts and Parts | |||
pulser coil | Gas EZGO | |||
G1 Pulser coil | Gas Yamaha |