|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
05-04-2018, 02:38 PM | #1 |
Not Yet Wild
Join Date: May 2018
Posts: 1
|
eh35 Cam Seal Pushing Out
I just rebuilt the Robin eh35 engine in my 92 ezgo. Had it bored to I believe .35 over, or whatever the next standard size was available in the rebuild kit. Had no issues, ran great. Put about 5 hours on it.
Decided to change the oil. Cleaned oil filter, reinstalled, put 1.5 quarts of oil in it. Ran great on test runs and no leaks. All of the sudden oil trail and oil everywhere. Determined it was coming from the rear (clutch side) cam seal. Disassemble that side of the engine and sure enough the cam seal was pushed out. Seconding guessing myself now if I has properly seated the replacement seal during the rebuild. Clean everything up, reseat the seal, reassemble the engine, add oil, test run, runs great. Wife calls while I'm at work, oil pouring out again. No doubt the cam seal again from what she is describing. Why is the cam seal pushing out now? |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Robin EH35 build shop | Gas EZGO | |||
eh29 head on eh35 block | Gas EZGO | |||
Yamaha G1 backfire pushing out Clutchside Crankshaft Oil Seal | Gas Yamaha | |||
WANTED eh35(350) CALIF. | Golf Carts and Parts | |||
Want to buy EH35 Ezgo engine | Golf Carts and Parts |