|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
02-23-2018, 11:11 PM | #1 |
Not Yet Wild
Join Date: Feb 2018
Posts: 34
|
secondary spring
Hi everyone, I'm new to the cart thing and have been reading threads on G9's till my head was spinning. I think the best thing for me to do is take one problem at a time. I was looking at my driven clutch and didn't see any kind of plastic sliders and it has a white spring. Is this a bad thing? Also I need a new primary clutch, any recomendations? thanks
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
02-23-2018, 11:36 PM | #2 |
Gone Wild
Join Date: Jun 2015
Location: NW Iowa
Posts: 1,669
|
Re: secondary spring
Yes there should be three ramp shoes (plastic sliders) if the primary is worn out pull the belt off and check the sheaves if there's grooves you might me better off buying new secondary as well
|
02-24-2018, 01:42 AM | #3 |
Gone Wild
Join Date: Jun 2015
Location: Philippines
Posts: 570
|
Re: secondary spring
|
02-24-2018, 05:55 PM | #4 |
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,443
|
Re: secondary spring
The spring should be inside 3 ramps around it, with plastic shoes that slide on the ramps. A white spring is likely aftermarket and very strong. If the cart is lifted springs can help, usually not needed (unless towing/etc) if not lifted though old springs do loose strength over years.
|
02-24-2018, 06:43 PM | #5 |
Not Yet Wild
Join Date: Feb 2018
Posts: 34
|
Re: secondary spring
thanks, yes, the cart has a Jake's lift kit and big tires. I'll have to take pictures because I also have issues with the drive clutch and not sure of options or where to start
|
02-24-2018, 07:59 PM | #6 |
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,443
|
Re: secondary spring
What primary do you have? G9 has weights in it and later replacements have rollers, or it could be aftermarket.
Usually yami clutch primary you take the cover off and inspect for broken weights or links or bad rollers. Secondary check the ramps for smoothness, shoes on ramps, grease both with 1-2 pumps only at fittings. Aftermarket comet for example are different, they don't have a cover to take off unless its the dust cover. Check the moving sheaves on each for wobble, they are not tight but should not wobble much. Check the aluminum sheaves for wear from belt, the belt will dish them in and eventually wear through them. Dish in makes them shift more poorly, makes them like a 1.25 wide belt more. It is mostly from sand on the belt makes that wear more. This is a stock G9, the primary cover comes off with screws around the outside edge of it to inspect. https://www.youtube.com/watch?v=XksLJlvY6KA The grease fitting is near one of the screws, fitting on secondary is on back side near a ramp. Make sure no grease comes out in the center shaft and gets on the belt, that is why 2 pumps max. |
02-24-2018, 08:13 PM | #7 |
Not Yet Wild
Join Date: Feb 2018
Posts: 34
|
Re: secondary spring
the primary has weights, one of the plastic slides is missing and the sliding sheave has holes in it. the fixed sheave feels worn. I will get pictures and have son upload them.
|
02-24-2018, 08:17 PM | #8 |
Not Yet Wild
Join Date: Feb 2018
Posts: 34
|
Re: secondary spring
a primary cover came with the cart but was damaged and off when I got it.
|
02-24-2018, 10:18 PM | #9 |
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,443
|
Re: secondary spring
Sliding sheave has holes worn into it, it is toast. They are expensive now it can be a better deal to get another clutch. I had slides but think I sold them. The fixed was steel and did not wear much unlike the aluminum part. I rebuilt one with a new sheave and weights but the price is much higher last time I looked. They last forever figure yours is maybe almost 30 yr old. Mine was '92 and it was nearly worn through when I put a 94c clutch on it, I put 3 sets of used weights in it lol. I got that cart in '99. I kept it for a spare but drilled the weights for my clone.
|
02-24-2018, 10:23 PM | #10 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: secondary spring
Did you guys see what they did with the Umax spring? $95 now? Wtf
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Secondary Spring setting need help | Gas Yamaha | |||
G16- secondary spacer / spring | Gas Yamaha | |||
secondary spring | Gas Yamaha | |||
secondary clutch spring | Gas Yamaha | |||
09 ST secondary spring | Gas EZGO |