07-26-2011, 02:39 AM | #11 |
Gone Wild
Join Date: Dec 2010
Posts: 488
|
Re: wireing
The 1/2 speed reverse is achieved thru a 5.1k resistor in the throttle wiring.On the outer microswitch of the fwd/rev there are 3 terminals the top has a green wire the middle black and the lower white. The black has the resistor. Try switching the middle and bottom wire. see sonics wiring diagram.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-26-2011, 11:01 AM | #12 |
Gone Wild
Join Date: May 2009
Location: roseville , michigan
Posts: 196
|
Re: wireing
sorry did not post they are 87 electronics
|
07-26-2011, 11:29 AM | #13 |
Ban Puppy Mills & Stores!
Join Date: Dec 2008
Location: SE Florida
Posts: 2,955
|
Re: wireing
jim777, I just spoke with TahoeDawg and he stated that all you need to do is change the wire on the S1 post on the motor to the S2 post on the motor and vice versa.
|
07-26-2011, 12:17 PM | #14 |
Gone Wild
Join Date: May 2009
Location: roseville , michigan
Posts: 196
|
Re: wireing
thx for the info ill try it thx jim
|
07-26-2011, 12:35 PM | #15 |
Gone Wild
Join Date: May 2009
Location: roseville , michigan
Posts: 196
|
Re: wireing
now im getting full speed forward but the selector is in reverse and half speed reverse with the selector in forward
|
07-26-2011, 01:44 PM | #16 |
Gone Wild
Join Date: Dec 2010
Posts: 488
|
Re: wireing
|
07-26-2011, 03:19 PM | #17 |
revolutiongolfcars.com
Join Date: Mar 2010
Location: Golf Car Capital of The World... Augusta, Georgia
Posts: 10,224
|
Re: wireing
Swap the wires back like you had them, and switch the middle and bottom wire on the Half speed micro switch. It's the one closest to the battery pack.
|
07-26-2011, 03:20 PM | #18 |
revolutiongolfcars.com
Join Date: Mar 2010
Location: Golf Car Capital of The World... Augusta, Georgia
Posts: 10,224
|
Re: wireing
Sorry Scuba, didn't mean to misinform. Wasn't aware that he was running an EZGO motor. I'm assuming it's on an EZGO transaxle as well, which is completely opposite from our stuff as far as which direction the motor attaches from.
|
07-26-2011, 04:43 PM | #19 |
Gone Wild
Join Date: May 2009
Location: roseville , michigan
Posts: 196
|
Re: wireing
it is on a par car rearend will it screw anything up to run it like it is
|
07-26-2011, 05:36 PM | #20 | |
Ban Puppy Mills & Stores!
Join Date: Dec 2008
Location: SE Florida
Posts: 2,955
|
Re: wireing
Quote:
Most importantly thanks for jumping in and helping Jim777... that was my real concern and you did just that |
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Wireing diagram | Gas EZGO | |||
Wireing Diagrams | Electric golf carts | |||
wireing tip | Garage and Workshop | |||
Problems Wireing Lights | Electric EZGO |