|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
05-17-2019, 09:23 PM | #1 |
Not Yet Wild
Join Date: May 2019
Posts: 6
|
2006 precedent new solinoid no go
I picked a 2006 precedent that was sitting for years. I've replaced the batteries, and replaced the solenoid. Flip the switch from tow to run and the solenoid clicks but don't go. When I release the gas pedal and reengage it wont click until I switch the run tow switch again.
If I jump the two large terminals it moves at half speed. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-17-2019, 09:33 PM | #2 |
Gone Wild
Join Date: May 2015
Location: Houston
Posts: 903
|
Re: 2006 precedent new solinoid no go
Did you install the precharge resistor? Also,MCOR could be bad. Does reverse buzzer sound when placed in reverse?
|
05-17-2019, 10:00 PM | #3 |
Not Yet Wild
Join Date: May 2019
Posts: 6
|
Re: 2006 precedent new solinoid no go
Yes I replaced the resister and the reverse does buzz
|
05-20-2019, 10:41 AM | #4 |
Not Yet Wild
Join Date: May 2019
Posts: 6
|
Re: 2006 precedent new solinoid no go
More details With the relay jumped
the cart moves forward and reverse the cart changes speed with pedal movement with the charger hooked up shows good charge and auto shuts off when fully charged Im assuming the MCOR works with the micro switches and the OCR is functioning normal do to battery charger indications. The fact that I can drive it while jumped should indicate the motor is good. If I disconnect the relay jumper the cart doesn't move forward or reverse. Am I looking at a bad controller? |
05-20-2019, 10:48 AM | #5 |
Gone Wild
Join Date: Sep 2012
Location: Charlotte, NC
Posts: 9,329
|
Re: 2006 precedent new solinoid no go
Make sure the diode on the Solenoid coil is properly installed and working.
The banded side of the diode needs to be on the same Solenoid terminal as the light blue wire. Are you saying the Solenoid clicks as soon as you flip to RUN and without pressing the pedal? |
05-20-2019, 08:44 PM | #6 |
Not Yet Wild
Join Date: May 2019
Posts: 6
|
Re: 2006 precedent new solinoid no go
No when I first put the tow/run switch to run with the key on...The solenoid clicks once and nothing. It doesn't move and then it doesn't click any more.
|
05-20-2019, 08:45 PM | #7 |
Not Yet Wild
Join Date: May 2019
Posts: 6
|
Re: 2006 precedent new solinoid no go
sorry clicks once when I push the gas pedal.
|
05-24-2019, 02:44 PM | #8 |
Not Yet Wild
Join Date: May 2019
Posts: 6
|
Re: 2006 precedent new solinoid no go
I just replaced the control module and cart runs like a dream.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
2006 EZGO TXT - No Solinoid Click | Electric EZGO | |||
04 Precedent IQ No power No solinoid click | Electric Club Car | |||
2006 precedent gas | Gas Club Car | |||
2006 precedent got wet. | Electric Club Car | |||
Should I buy a 2006 CC Precedent | Electric Club Car |