|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
09-22-2020, 10:10 AM | #11 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: TXT '01 PDS No solenoid click, reverse buzzer, and wont go
Quote:
2. The voltage to Pin-7 goes through several switches, plus through several plug/jack contacts as well as several connections inside the controller, so spray cleaning the plugs and jacks may help. Attached is a drawing of the voltage paths through a stock PDS controller. |
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-22-2020, 10:33 AM | #12 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: TXT '01 PDS No solenoid click, reverse buzzer, and wont go
Quote:
2. Normal. 3. Please list which manual and what page where you found the quoted statement. 4. Logic power is the voltage that comes through the reed switch and enters the controller on J1 Pin-4. A truth table (logic diagram) can be applied to what has to happen in order for a PDS controller to operate and the voltage that goes through all the steps on the truth table is called logic power. |
|
09-22-2020, 10:50 AM | #13 | ||
Not Yet Wild
Join Date: Aug 2020
Posts: 12
|
Re: TXT '01 PDS No solenoid click, reverse buzzer, and wont go
Quote:
Quote:
On page 73 it's got No Buzzer in the troubleshooting chart there with Corrective Actions listed. |
||
09-22-2020, 11:17 AM | #14 | |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: TXT '01 PDS No solenoid click, reverse buzzer, and wont go
Quote:
Make sure the solenoid has a 36V coil and the contacts ought to be rated at 100A or more. Page 73 of 228 in Adobe Acrobat Reader, which is Page F-7 in the manual, says "Repair/replace logic power". The articulation of EZGO's tech-writers at the time, needed some grooming |
|
09-22-2020, 11:57 AM | #15 | |
Not Yet Wild
Join Date: Aug 2020
Posts: 12
|
Re: TXT '01 PDS No solenoid click, reverse buzzer, and wont go
Quote:
I used E-Z-GO 36 Volt Solenoid Electric Models from buggies unlimited https://www.buggiesunlimited.com/gol...c-models)/1125 I didn't secure the inner nut on the small studs when putting on the blue and yellow wires, though I may sure not to over torque them - that may have caused the damage. |
|
09-26-2020, 12:27 AM | #16 |
Not Yet Wild
Join Date: Aug 2020
Posts: 12
|
Re: TXT '01 PDS No solenoid click, reverse buzzer, and wont go
Well I changed out the solenoid and no cigar. I did notice on J4 coming from the pedal switch 1 has pack voltage and 2 has 36.8 like half the connections on J1 does. Looks like they connect inside the controller? Does this indicate a controller failure?
|
09-26-2020, 10:00 AM | #17 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: TXT '01 PDS No solenoid click, reverse buzzer, and wont go
The image I attached to Post#11 shows how the control voltage(s) pass through the controller.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
2014 Precedent- no power- no buzzer- no solenoid click....nuthin | Electric Club Car | |||
Cart no forward no reverse no click but has rev buzzer | Electric Club Car | |||
96 club car ds solenoid wont click and cart wont move unless you jump solenoid | Electric Club Car | |||
97 TXT, won't click solenoid or run,reverse buzzer on constantly | Electric EZGO | |||
96 DCS, no buzzer, no solenoid click | Electric EZGO |