Club Car DS 2007 - Speed increase options

[tico21]

Hey Folks,

looking for advice so after changing my magnet only registering speeds unto to 16 mph...

wonder what could be the problem could be ?

[CP241]

Make sure the speed sensor isn’t damaged. What kind of battery voltage do you have before driving it? What does your voltage do while you are driving it?

[movin-on]

Make sure that you are getting full throttle and that the drive bar isn't worn which is a common problem on a ds by not allowing the mcor to go to 100 percent.. ...How much travel do you have on the go pedal before you hear the solenoid click...Should be about an inch...

[tico21]

Thank you all for the advice ...looking into the suggestions tomorrow.

[tico21]

I have too much travel ! were can i get a new a drive bar ?
is there a sticky on how to change it on the forums.

[CP241]

Originally Posted by tico21

I have too much travel ! were can i get a new a drive bar ?
is there a sticky on how to change it on the forums.

You can use a bit of 1/4” fuel line and a zip tie around the bar to take up the slack. Works fine, I did that on mine over a year ago and it still works perfect

If nothing else it’ll get you by until you can fix it right. I just haven’t felt that need yet, and once this hose wears out I’ll probably just cut it off and put a new one on

[movin-on]

Originally Posted by tico21

I have too much travel ! were can i get a new a drive bar ?
is there a sticky on how to change it on the forums.

Look at this thread..There are a few pics...You can use fuel line instead of a zip tie...They both work..

https://buggiesgonewild.com/showthre...433#post258017

[CP241]

Originally Posted by movin-on

Look at this thread..There are a few pics...You can use fuel line instead of a zip tie...They both work..

https://buggiesgonewild.com/showthre...433#post258017

I hadn’t seen that. I did the same thing he did in that thread, but ran the zip tie through the center of a piece of fuel line. I didn’t have any zip ties that were fat enough… and the only fuel line I had handy was the yellow flexible stuff that was too thin on its own to fit over the shaft and take up the slack. Worked out perfectly. I keep meaning to change it, but why fix what ain’t broke!

[tico21]

Hey guys used a piece of fuel line and it worked ! Clocked22 mph today that GE motor is a beast!! Thanks guys

[CP241]

Originally Posted by tico21

Hey guys used a piece of fuel line and it worked ! Clocked22 mph today that GE motor is a beast!! Thanks guys

Good job. Now go enjoy it!