|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
01-12-2022, 01:58 PM
|
#1 |
|
Not Yet Wild
Join Date: Sep 2017
Posts: 1
|
Alltrax Regen Diode Installation
In my 36V 2005 EZGO TXT PDS, I am upgrading my stock curtis controller and solenoid with an ALLTrax 400 XCT and Curtis SW180 solenoid. The solenoid came with a diode connecting 2 of the small terminals and a resistor connecting the 2 large terminals.
In addition, a Regen Diode came in the box with the Alltrax XCT, with install instructions. The Regen Diode instructions are straight forward, it looks like I connect the 2 large terminals on the solenoid with the stripe on the + battery side but I'm confused what I do with the resistor that came installed on the solenoid? Do I leave it on and also install the regen diode with it? Or one or the other? It's the last thing I have to wire, so I am right at the finish line! |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
01-12-2022, 02:01 PM
|
#2 |
|
Gone Wild
 Join Date: Apr 2013
Location: Deep Run, NC
Posts: 2,544
|
Re: Alltrax Regen Diode Installation
The resistor is not needed on the XCT controller. Only the regen diode. The precharge is done internally.
Sent from my SM-G991U using Tapatalk |
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Diode Installation | Electric Yamaha | |||
| Regen Diode | Electric Club Car | |||
| Regen diode | Electric EZGO | |||
| Regen diode? | Electric EZGO | |||
| alltrax dcx 300 resistor and diode question | Electric EZGO | |||
Linear Mode
