06-21-2021, 12:42 PM | #27 |
Not Yet Wild
Join Date: Jan 2020
Posts: 39
|
Re: Lithium Conversion 48 volt system
Thanks, I understand. With that said the BMS FET will fry if I try to run everything through it. I know there are some nice drawings out there on how to setup a switch to cut off the power using the BMS info, without running through the FET during operation. I will study up on it. The loose connection was confusing the curtis controller which in turned was sending out faults. I have at least corrected that problem. The individual cells for now are level +- 80 mv, and I charge through the BMS, so it will not overcharge if a single cell is low. This does not prevent, as you state, issues with LVC.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Alibaba Lithium for a Navitas 72V AC System | All things Lithium | |||
Lithium conversion | Electric Club Car | |||
2018 RXV Elite- 90 AMP Lithium system | Electric EZGO | |||
WTB Lithium Conversion | Electric Club Car | |||
Replacing A Lester 48 Volt System with a NEW Self Contained On-Board System | Electric Club Car |