|
Electric Yamaha Electric Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
12-21-2017, 12:20 PM | #11 | |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,406
|
Re: Converting g2 to solid state with ezgo txt internals
Quote:
|
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
12-21-2017, 01:19 PM | #12 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Converting g2 to solid state with ezgo txt internals
Well, that helps. Alltrax's can use many different throttle types. You can convert your existing wiper board to act like a 0-5000 ohm throttle quite easily, and the Alltrax's will support it. That would be much easier than working a ezgo ITS into your cart.
|
12-21-2017, 02:48 PM | #13 |
Not Yet Wild
Join Date: Feb 2017
Posts: 4
|
Re: Converting g2 to solid state with ezgo txt internals
So with the alltrax controller and TXT motor what else will I need? You said the forward reverse selector will work? Also what will I need to do about the pedal? Do y'all know if that motor will bolt up to my existing axle?
|
12-21-2017, 02:53 PM | #14 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Converting g2 to solid state with ezgo txt internals
Ezgo 19 spline motor won't fit. Club car 10 spline motors will work. They must be same type motor, a sepex motor must be paired with a sepex controller, series motor to series controller. Not sure if you said what controller type it was.
Last edited by cgtech; 12-21-2017 at 04:34 PM.. Reason: Fat fingered a number |
12-21-2017, 03:28 PM | #15 |
Not Yet Wild
Join Date: Feb 2017
Posts: 4
|
Re: Converting g2 to solid state with ezgo txt internals
It's an alltrax controller. I can get a ezgo axle so I'll prolly just swap my axle. So that puts me with an ezgo motor and axle with an alltrax Controller. I believe the cart I'll get the axle off of also has a pedal assembly I can get as well. That should be everything I need
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Solid state conversion on 87 ezgo | Electric EZGO | |||
Question on Converting a Cushman Gc400 to solid state comtroller. | Electric golf carts | |||
Converting 85 DS to Solid State | Electric Club Car | |||
Need CC 36V resistor to EZGO solid state diagram | Electric Club Car |