|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
03-18-2021, 07:03 PM
|
#11 |
|
Gone Wild
Join Date: Sep 2020
Location: Germany
Posts: 2,000
|
Re: Any tricks to installing AMD 7126?
Only my experience with the input shaft of a noisy rxv rearend i've changed. The i/s gear had visible wear, with the new one installed, not any better. Input shaft, intermediate and main gear effected each other. I finally decided to purchase a complete new transaxle...
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
03-19-2021, 08:52 AM
|
#12 |
|
Master of All Things
 Join Date: May 2013
Location: West Columbia, Texas
Posts: 17,998
|
Re: Any tricks to installing AMD 7126?
Grady, something no one has mentioned yet and is often over looked, look INSIDE the coupler of your old motor. you should find a rubber bumper in the bottom of it. get it out, clean it up and install it in the new motor. its likely it didn't come with one. other than that....replacing the motor is truely P-N-P.
|
|
|
|
|
03-19-2021, 08:55 AM
|
#13 |
|
Gone Wild
Join Date: Dec 2020
Location: Texas
Posts: 170
|
Re: Any tricks to installing AMD 7126?
Thanks Nuke. I already made sure to grab that as I noticed the new one did not have it ;)
R |
|
|
|
|
03-19-2021, 07:05 PM
|
#14 |
|
Gone Wild
Join Date: Dec 2020
Location: Texas
Posts: 170
|
Re: Any tricks to installing AMD 7126?
Okay... ordered a new spindle bumper.. the other one is stuck... also ordered 6 US 8VGCHC XC2 batteries and a Summit II charger.. so.. should have all the parts middle of next week to finish putting this together.. heh....
R |
|
|
|
|
03-22-2021, 12:19 PM
|
#15 |
|
Gone Wild
Join Date: Sep 2020
Location: Green Cove Springs, FL
Posts: 177
|
Re: Any tricks to installing AMD 7126?
One more input that you may want to consider. When you install the new bumper I would make sure the motor housing slides up to the rear end housing all the way or very close. If you have to pull it together with the motor bolts you may be putting too much force on the motor bearings and possible cause them to burn up. This tip was given to me by Robbie at Plum Quick motors.
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| AMD 7126 for a series EZGO real world question . | Electric EZGO | |||
| About to Install Raptor (7126) Motor | Electric EZGO | |||
| Series cart, 48volt, 7126 AMD motor? | Electric EZGO | |||
| Installed the AMD 7126 | Electric EZGO | |||
| amd 7126 raptor or 7122 | Electric EZGO | |||
Linear Mode
