Ez go series cart diagram

[integraracing04]

Need a picture of someones ez go 36 volt series cart of the direction swtich wiring. Need specifically the microw switch diagram cuase everytime i hit the gas it burns out the footbox micro switch and i think someone wired the direction switch wrong.

[rabbitreborn]

Not a picture but this should help anyway......

Txt solenoid activation
power starts on the white wire on the 36+ of the battery pack.
Power travels to the charger receptacle, goes through a reed switch inside the receptacle and comes out on the red 12 gauge red wire. ( check for power here, 1st!)
the red wire travels back through the loom to the forward and reverse switch where it attaches to a micro.
The other side of that micro has a blue wire attached that runs under the cart to the front and arrives at the keyswitch.
The keyswitch then transfers power to a green wire which returns to the area of the forward and reverse switch.
The power then goes through a 4 pin molex connector and travels to the "pedal box" (located under the floorboard of the car) where it goes through a micro and comes out on another red wire.
That red wire comes back up to the controller/f&r area where it once again goes through the 4 pin molex connector and continues on to the small post of the solenoid.

[integraracing04]

the red wire that runs through the wire loom is connected directly on the battery along with the white wire that goes to the charger receptical. everything else that you said is right. whats the next step i should take....?

[rabbitreborn]

yeah alot of people do that bypass of the reed switch....

did you follow the power? was the voltage correct all along the line?