|
12-08-2014, 07:09 PM
|
#1 |
|
Not Yet Wild
Join Date: Sep 2014
Posts: 10
|
No power
My 1999 ezgo does good on flat or pulling small incline but if you pull front tires up to a small curb it want pull over it . The motor is not revving up so the belt is not slipping . I think I might be having clutch problems the rear clutch was not engaging so I put a little oil on it and let it set for a while and tapped it with a hammer it started engaging then . So I am asking if I need to get all new clutches or do something else. Thanks
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
12-09-2014, 12:08 AM
|
#2 |
|
It ain't gonna be easy.
Join Date: Apr 2008
Location: St. George, SC
Posts: 1,480
|
Re: No power
The buttons in the rear driven clutch may be worn. Cheap to replace.
|
|
|
|
|
12-09-2014, 07:26 PM
|
#3 |
|
Not Yet Wild
Join Date: Sep 2014
Posts: 10
|
Re: No power
Thanks I will see if that is it . What do I look for and do I take clutch off to do that
|
|
|
|
|
12-09-2014, 08:22 PM
|
#4 |
|
Gone Wild
 Join Date: Sep 2012
Location: Missouri
Posts: 2,755
|
Re: No power
I would pull the clutch apart and clean it. I'd also lube the shaft while apart. The inner sheave slides on the shaft and may be dry not allowing the sheave to move in and out as needed to engage and shift fully.
|
|
|
|
|
12-09-2014, 11:20 PM
|
#5 |
|
It ain't gonna be easy.
Join Date: Apr 2008
Location: St. George, SC
Posts: 1,480
|
Re: No power
|
|
|
|
|
12-10-2014, 09:15 AM
|
#6 |
|
Gone Wild
Join Date: Dec 2007
Posts: 391
|
Re: No power
Just curious for my education. The OP says the motor is not revving. How is this a clutch problem if the motor is not doing anything? I know he said something about the clutch, but if the motor is not revving how is the clutch going to engage anyway.
Sorry if I misunderstand! |
|
|
|
|
12-10-2014, 10:46 AM
|
#7 |
|
It ain't gonna be easy.
Join Date: Apr 2008
Location: St. George, SC
Posts: 1,480
|
Re: No power
It almost sounded like he meant the motor was boggin down. Idk. He will need to give a little bit more info. Like maybe pulling the seat and watching the clutches move along with the belt while sitting on a 2x6. But if the driven clutch is sticking it could be worn buttons which leads toworn rramps due to the bolt heads digging into them.
|
|
|
|
|
12-10-2014, 03:11 PM
|
#8 |
|
Gone Wild
Join Date: Feb 2011
Posts: 1,515
|
Re: No power
Sccowboy (Correct) Had it happen just a bit ago. The secondary clutch bound in the open position due to lube and a worn bushing the primary closed but it tries to move which seems like HIGH gear. Made it close
 and lubed it with dry lube and good to go. It will move when this problem occurs but has NO power. LOU |
|
|
|
|
12-10-2014, 06:11 PM
|
#9 |
|
It ain't gonna be easy.
Join Date: Apr 2008
Location: St. George, SC
Posts: 1,480
|
Re: No power
Right ... a basic gear ratio issue.
|
|
|
|
|
12-10-2014, 06:44 PM
|
#10 |
|
Gone Wild
Join Date: Dec 2007
Posts: 391
|
Re: No power
so does the motor rev with this happens or does it just sit there and do nothing?
|
|
|
|
 |
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| G1 not starting...no power power coming from magneto? | Gas Yamaha | |||
| Full power in reverse, part power in forward | Electric EZGO | |||
| Ezgo dies under power then regains power | Electric EZGO | |||
| 2005 Precedent starts of powered, then loses power, reverse always power | Electric Club Car | |||
| Power Wise Charger worked after board replaced now back to no power | Electric EZGO | |||
Linear Mode
