Need help with input shaft

[ZZTOP]

If you changed the input shaft bearings, and have the axle bearings out of the rear, and it is still making the noise. There is only 4 more bearings in the rear. Two are a little pain to change, and the other two are easy

[Dncastillo0728]

I changed just the input shaft bearings. Did not change the input shaft

[ZZTOP]

Ok there's a few things you can do to find out what it is

Does it make the noise when you push the cart?

it can be one of the other 4 bearings in the rear, or the motor bearing.

Did you try and push the cart and spin the wheels after you put the new input bearings in to see if it made the noise, before you bolted the motor back on?. There is a few ways to go about this.

remove the motor, slide the axles back in and push the cart to see if it still makes the noise with out the motor bolted on the rear. If so, It will be one of the bearings in the rear end. If it don"t make the noise with the motor removed and the axles in?, then it is the bearing in the end of the motor

[Dncastillo0728]

I will take out motor Thursday and push and see if it makes noise. If it still does then I can say it is the other 4 bearings. Anybody have parts numbers for rear bearings? Part number for bearing on motor ?

[ZZTOP]

[Dncastillo0728]

I took out the motor and pushed the cart and it sounds the way it should so it looks like the bearing in the end of the motor. I have the advanced motor. How would I change that?