|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
10-22-2020, 10:28 AM
|
#1 |
|
Not Yet Wild
Join Date: May 2014
Location: Magnolia, TX
Posts: 24
|
02 txt 400 amp solenoid
In the process of upgrading controller and motor. Figured i'd do solenoid and switch also. Just want to verify that my diagram is correct for solenoid. Any input would be appreciated before i start tightening everything down. Thanks.
 Sent from my SM-N960U1 using Tapatalk |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
10-22-2020, 10:43 AM
|
#2 |
|
Happy Carting
 Join Date: Dec 2007
Location: Southern California
Posts: 73,418
|
Re: 02 txt 400 amp solenoid
The solenoid you show has no polarity mandate. That means the small + and - can go on either side and the same is true for the big cables. Also the big cable location has no bearing upon the small wire + and - location.
|
|
|
|
|
10-22-2020, 11:25 AM
|
#3 | |
|
Not Yet Wild
Join Date: May 2014
Location: Magnolia, TX
Posts: 24
|
Re: 02 txt 400 amp solenoid
Quote:
Sent from my SM-N960U1 using Tapatalk |
|
|
|
|
|
10-22-2020, 12:08 PM
|
#4 | |
|
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: 02 txt 400 amp solenoid
Quote:
The banded end has to face the small terminals with the red wires on it. Neither the solenoid coil or contacts are polarized, but the diode is. The diode is correctly installed in the picture. |
|
|
|
|
|
10-22-2020, 02:31 PM
|
#5 | |
|
Not Yet Wild
Join Date: May 2014
Location: Magnolia, TX
Posts: 24
|
Re: 02 txt 400 amp solenoid
Quote:
Sent from my SM-N960U1 using Tapatalk |
|
|
|
|
|
05-23-2021, 01:23 PM
|
#6 |
|
Not Yet Wild
Join Date: Jun 2020
Posts: 4
|
Re: 02 txt 400 amp solenoid
Do you need to install the resistor and diode? Also can you switch the RXV stock resistor wires? current configuration will not reach the new solenoid location. Thanjs
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Solenoid Not Clicking after installing new Batteries and new Solenoid | Electric EZGO | |||
| 1989 Club Car DS 36v -New Vglide/Solenoid/microswitches Only moves when solenoid jump | Electric Club Car | |||
| Wrong Solenoid in my cart? w/ Pics- Please suggest correct solenoid I should be using | Electric EZGO | |||
| Solenoid not engaging with Forward / Reverse switch? (Solenoid is good) | Electric EZGO | |||
| Help converting G1 solenoid setup to single G16 solenoid | Gas Yamaha | |||
Linear Mode
